2001 toyota 4 runner fuel pump realy location

SOURCE: 2001 toyota 4 runner headlights will not work

bridging wire one to two makes it live at fuses only....but does not ignite the headlights.

SOURCE: replace front brake pad 2003 toyota 4 runner

Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers

SOURCE: How can I disconnect the power antenna from my

Does it keep running all the time and you just want it to stay up. They"re not that hard to replace.
The radio power triggers the antenna and the ant motor can be disconnected in the pass wheel well.

SOURCE: toyota 2001 4 runner vsc lights on and trac

Those lights always come on whenever the check engine light is on.It could be from the gas cap not being tight enough or an air hose in the engine compartment coming loose. I recommend bringing your vehicle to someone that can read the codes and reset the lights for you. The codes will narrow down what the problem really is.

SOURCE: water leak under the intake manifold,1995 toyota 4 runner

There is a heater core bypass pipe that runs from the block (under the manifold) to the bacl of theengine where you will see a flat rectangular "sheet metal" thing with a pipe coming out of it. The a rubber hose connects. You need to pull the top air plenums and intake to get to it. The p[ipe flange bolts to the block with silicone rtv as a sealant.

Testimonial: "thanxs"