My 2007 vw touareg mirrors both sides do not operate up & down or in & out. I can hear the motors on both working but the mirrors are not moving

SOURCE: My front driver side power window is not working

you have to replace the window regulator reason why is because the cable ripped which would cause the motor to work without moving the window up or down .. regulator is the cable and the rails were the motor makes the woindow move up and down on. you have to replace it.

SOURCE: number fuse for side mirror motor 2007 Beetle VW?

Fuse # 5 its 7.5A or 5A
located in the fuse panel behind left side of dash
I would check the switch also
do not remove the fuse and drive car around
it control other components
good luck

SOURCE: how to remove inside door panal to replace window motor?

Remove the window switch bezel. It has a snap clip in the front just pry the front up with a pick or small screw driver the pull it forward and disconnect. Remove the plastic covers from the ends of the pull strap and remove the 2 screws.Then locate the 2 screws at the bottom of the door panel and remove.Then pull out on bottom of door panel and work your way up to release the plastic push pins.

Harvey N Tawatao

• 3854 Answers
• Posted on Jul 02, 2009

SOURCE: Interior Fan Motor won't stop 2004 VW Touareg

Find and replace the Blower fan relay, not sure where it is on your VW but it's common to be in with the fuse box by the battery. Good luck and hope this helps. When the relay goes bad from the heat of the electrical current, it seizes and does not disengage keeping the connection causing the ran to keep running. 

SOURCE: Brake Pad Replacement,2004 VW Touareg,V6 instructions

Same as any other vehicle.

1. Raise and support vehicle
2. Remove tire/wheel
3. Loosen/remove the two caliper bolts
4. Slide caliper off the rotor.
5. Use a C-Clamp to depress the caliper piston
6. Remove old pads from caliper
7. Install new pads on caliper
8. Install caliper/tighten caliper bolts
9. Install tire/wheel
10.Lower vehicle
11 Move to next wheel/repeat

Some people take a turkey baster and remove some of the brake fluid from the master cylinder prior to depressing the caliper piston because it can over flow. If you choose to do that just add the fluid back when finished so it is at its proper level.