2004 chrysler concorde not starting cold, engine pops but wont catch and start

mike loshbough

• 1011 Answers
• Posted on Jan 25, 2009

SOURCE: 2004 sebring 2.7 engine, will strt when cold but not when warm

more than likely a bad crank sensor but not knowing if there are codes might also be a cam sensor,it is deffently a electrical componet problem hot soak of the motor will break down bad electrical sensors,

SOURCE: Chrysler Concorde LXI 4 door - 2004 The car starts up and seconds after, the RPM drops and the car shuts off. The code P0513 comes up on the computer.

That is a code for an invalid skim key. If you have another skim key try it. If it does the same thing then the skim module may be bad.

SOURCE: I have a 2000 chrysler concorde that the engine light just popped on - the error codes are po302, po420, po340

P0302-cylinder #2 misfire detected
P0420- catalyst efficiency below threshold bank 1
P0340-No cam signal at PCM.
The Cam sensor most likely needs to be replaced first. Clear the codes after that and drive and see what comes back on.

SOURCE: will only blow cold air , sometimes it will blow hot

sounds to me like a blend door problem or blend door actuator problem

SOURCE: 2002 chrysler concorde intermitently will not

could be crank sensor, but also could be fuel pump. you need to know...when it does not start, do you have spark? do you have fuel?
you did not list your engine size, but these are basic. i have worked of concordes quite a bit. i would guess w/oi seeing the car that it would be a crank or cam sensor issue.