SOURCE: CHECK ENGINE BULB REPLACEMENT
You have to take all the facia off the dash - and then pull the dash cluster out. It is a long hard job for a light bulb. When you take the dash out don't forget to undo the speedometer wire and then the wire plugs on the left and right upper sides of the dash unit.
SOURCE: REPLACEMENT OF [LOW BEAM] HALOGEN BULB IN 2004 Buick LeSabre
I just Replaced a Low Beam Light bulb on a 2005 Buick La Sabre.
If You use a Metric socket and Remove the Two Silver bolts Attaching the headlight Assemble onto the metal surrounding the the lamp assembly it comes out to the front. This makes it much easier to access the bulb. Twist it counerclockwise & it comes out by pulling gently on the bulb. Then by realeasing a tab that is the socket holder bulb can be removed & replaced with a New #9006 low beam halogen light bulb. Wrap a Paper towel around the bulb & do NOT touch it with your bare hand as this wiil ruin a halogen bulb,
SOURCE: How do I change the turn signal bulb on a 2005
in the front, there should be two plastic clips (white or black) that you pull up on and that will release the entire front headlight assembly so you can then access the sockets for the individual bulbs.
As for the rear,I believe you just need to pull the trim of the trunk out of the way and you can access the rear of the light assembly right in the trunk
SOURCE: replacing brake light bulb
OPen the trunk and remove the access cover. The bulbs just twist out from the rear.
SOURCE: 2000 Buick Lesabre custom liscense plate bulb
kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together
72 views
Usually answered in minutes!
×