2001 vw beetle 1.8 turbo heater hose diagram please

all cars it is 1 of 3 places off the crank shaft
front ,center or rear,. some even are no the tranny flex plate.(crude reluctor)
the water beetle,
no country told. usa CAR IF YES WHY NOT SAY SO , WE USE JUST ONE 2.0l
NO ENGINE TOLD LOTS OF 2.0.
A5 BEETLE 2012-2013 TSI 2.0L??????

2013 VW beetle 2.0 TSI turbo engine. 16 VALVE?
THE EA888????? 3 generations of TSI MADE, GEN 2 IS 2008
197 bhp 2.0-litre turbo petrol engine
A5 BEETLE
VW OUCH
CALLS IT AND ENGINE SPEED SENSOR. SURE BUT IS NEVER IT'S PRIMARY GOAL EVER (rpm) THE GOAL IS EXACT SPARK AND INJECTION TIMING
NOT SPEED,
USA SHOP MANUAL SAYS.
Engine Speed Sensor G28 <<< BINGO REAL NAME FOUND, HARD TO DO.2.0l

1. On the front lower left side of the cylinder block, next to the oil separator. Refer to (see more...)
2. Removing and installing. Refer to Engine Speed Sensor G28, Removing and Installing.

PULL ENGINE COVER
Open the air guide pipe hose clamp 2
Disconnect the connector arrow.?Remove the noise insulation. Refer to see Noise Insulation; Overview - Noise Insulation.
?Remove the bolts 1 and 4 and remove the air guide hose downward from the Throttle Valve Control Module J338.
?Remove the air guide hose 1 from the charge air cooler and remove the air guide pipe downward.
Disconnect the connector 1 from the Engine Speed Sensor G28.?Remove the Engine Speed Sensor G28 bolt.

G28 IS SUPER SECRET CODE FOR CKP. (USA NAMES)

https://www.justanswer.com/vw-volkswagen/1wskx-fuse-box-diagram-2001-beetle-issue.html
http://90.gd.polizeichor-blaue-jungs.de/01-vw-beetle-fuse-box.html

Malinda, Order the routing sticker through the dealer if available or go to auto recycler and take picture, down load and print, laminate and stick on your car. Check the attached links pics. of vacuum lines. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2004 VW jetta 1 8 turbo vacuum hose diagram Google Search

2004 VW jetta 1 8 turbo emission diagram Google Search

The blower motor location on a 2001 VW Beetle 1.8 Turbo - Right Hand Drive (RHD) vehicle

The fuse panel on 2002 VW Beetle is located behind a plastic cover on the driver's side end panel of the dashboard, door open. See pictures below:





The fuse panel diagram:


Please do rate my response. Thanks!

I GET THE VAC DIAGRAMS I NEED FROM ONLINE AT AUTOZONE.COM....JOIN UP AND CHECK THEIR REPAIR GUIDES OUT...IT IS SAFE AND FREE

The P0238 code relates to a Turbo Boost sensor pressure High. The P0106 is a MAP sensor code and could be caused by a bad or loose hose to the MAP sensor and can cause the P0171 which is system to lean code. The P0297 is a vehicle overspeed code. Hope this helps you some.

would not recommend welding on the pan it should be replaced. diagram at autozone.com

Push the center piece, on the dash, forward until it unsnaps and exposes the screws for the passenger side piece. Take the piece off and you will see the filter bracket down in the dash. Remove the filter and replace with new one.

PLEASE DON'T FORGET TO RATE!

THANKS!

it is but if your check engine light is on there is some vaacium hoses than get crak and old make sure they are ok
but vacium leaks are more easy to find when ideling not under aceleration