I don't understand what your trying to do .If you are having problems with rod bearings on this engine scrap it torquing the bearing caps is not going to fix the problem ,
SOURCE: I need the torque specs
Main bearing bolts = 40 ft.lbs.
Connecting Rod Bearing Cap Nuts = 26 ft.lbs.
SOURCE: torque specs.
connecting rod = first pass 18 ft lbs , second pass 75 degrees
main bearings = first pass 37 ft lbs , second pass 77 degrees
wow that wasn't easy to find for some reason .
SOURCE: torque specs 7.5 inch rear axle 96 ford ranger
Differential bearing caps 70-85 ft lb
Ring gear bolts 70-85 ft lb
Pinion bearing preload if using original bearings 8-14 lb-in, if installing new bearings 16-28 lb-in
SOURCE: torque specs for toyota tercel
Hello vienotkelly: The correct Main bolt torque is 42 foot pounds. The connecting rods torque to 29 foot pounds. The torque sequence for the head bolts and the correct way to tighten the bolts are attached to this reply. Thak You for using
FixYa. Roger
SOURCE: Torque specs for 96 Honda Accord 2.2L
the main bearings bolts is to 1st step 30Nm or 22lbs ft and the last step is 75Nm or 54lbs ft in this tighten secuence. 9 3 1 5 7 on the top bolts and........ ........ ........ ... 8 6 2 4 10 botton bolts and the connecting rod 45Nm or 34 lbs ft i hope be help you
362 views
Usually answered in minutes!
×