2003 honda crv. how do i remove light bulb cover

The license plate lamps are designed to illuminate the plate and registration tags on your vehicle and make it easily visible to law enforcement. In many states, a burnt out license plate bulb can get you a ticket.
Step 1: Locate the license plate light. The license plate light is located right above the plate.
Step 2: Determine which bulb has failed. Park your vehicle and set the emergency brake. Turn the ignition to the Accessory position and turn on the driving lights. Walk around the vehicle to determine which license plate bulb has failed.
Step 3: Remove the license plate light cover. Remove the license plate light cover retaining screws using a screwdriver.
Remove the license plate light cover.

• Note: You may need to use a small screwdriver to pry the cover off.

Step 4: Remove the bulb. Remove the bulb from its retainer.
Part 2 of 2: Install the bulb Materials Needed

• Protective gloves
• Replacement license plate light bulb
• Safety glasses
• Screwdriver

Step 1: Install the new bulb. Install the new bulb in its retainer and ensure it is in place.

• Tip: Refer to your car's user manual to determine the correct type of light bulb to get for your specific vehicle.

Step 2: Complete the installation. Put back the license plate light cover and hold it in place.
Install the license plate light cover retaining screws and tighten them using a screwdriver.
Step 3: Check the lights. Turn on your car to check if your license plate lights are fully functional.

https://www.youtube.com/watch?v=sgzldlc_3kc . You can find the original manufacturer's horns for the Honda CR-V by raising the hood and looking at the front. There should be one horn on each side of the license plate behind the bumper.

check bulb the number plate light runs on the same circuit as the side lights so if they are working its got to be a bad earth on the plate light

Remove the two screws from the lens. Rotate the bulb holder 1/8 turn counter-clockwise and detach it from the lens housing. Pull the bulb straight out. Re-install in the reverse order.

Hi, you need "Sylvania ZEVO 2825 ZEVO LED"
search for it on ebay/Amazon or according to me Aliexpress Homepage
It's the biggest and cheapest worldwide suplier.
Just type the correct name into the searchbox and thats it
wish you luck

in your fuse panel check for faulty fuse ,or you might have to replace the whole assembly,if at the part store there is no replacement bulb then its not removeable.

YOU HAVE TO OPEN THE TRUNK LID REMOVE THE BLACK PLASTIC COVER FOR THE TRUNK LID LATCH.REMOVE THE LICENSE PLATE LIGHT HOUSING FROM THE TRUNK LID.REMOVE THE BULB SOCKET FROM THE LICENSE PLATE LIGHT HOUSING.TO REMOVE BULB FROM THE SOCKET SIMPLY PULL IT STRAIGHT OUT OF THE SOCKET.

The license plate lights are accessed by unscrewing the lens. The backup lightbulbs are accessed with the trunk lid open, behind the cover.

You should have two license plate lights, right above the license plate. If you remove the two screws that hold the one you want to change in, the entire fixture will drop down(best to do this with the trunk open). Remove the metal clip plate that covers the bulb. The bulb SHOULD simply pull directly out.
Hope this helps you.

Its a 5 Watt light bulb. Just pull it out and take it to the store with you. Just remove the license plate to get to it.