14-16 lbs. torque Torque the inner bolts first and work out to the front and rear bolts last.
SOURCE: i need rocker arm and
you should be able to get all that at the local auto parts store. Good Luck Tim
SOURCE: 02 Chevy avalanche 1500 need
1st pass 44 inch lbs
2nd pass 71 inch lbs, check the manifold joints for shifting and fix if needed
3rd pass 106 inch lbs
4th pass 11 ft-lbs
Start in the center and tighten in a criss-cross pattern.
SOURCE: Need torque specs for 2003 Nissan Murano AWD flex
Hello! Guru....Saailer
INTAKE MANIFOLD (sequence below)
STEP1........66"l bs. STEP2........21' lbs.
FLEX PLATE BOLTS
61" lbs.
FLEX PLATE to CONVERTOR
30' lbs.
Locktite on all the bolts.
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
SOURCE: Intake Manifold tightening sequence plus torque specs
start in the middle and alternate left to right and the torque on a alloy manifold will be around 14lbs or a nip with a 3/8th drive rachet ,any water passages use contact adhesive around the water ports .
Testimonial: "Thank you for the help......appreciate it"
Tighten the vertical lower intake manifold bolts (the four middle ones) to 7 Nm (62 lb in). Tighten the diagonal lower intake manifold bolts (two on each end) to7 Nm (62 lb in). Tighten the vertical lower intake manifold bolts (the four middle ones) to 13 Nm (115 lb in). Tighten the diagonal lower intake manifold bolts (two on each end) to 25 Nm (18 lb ft).
6,438 views
Usually answered in minutes!
×