First you need to know what your fuel pressure is. Install a fuel pressure tester to your fuel rail port and see what it is. Should be 48-50 psi.
SOURCE: car drops out at 2700 rpm and sputters
There is a rev limiter in these cars that disallows over revving in park or neutral. Does it climb past 2700 under hard acceleration?
SOURCE: hard shift from 1st to 2nd, then 2nd to 3rd.
Dont think they changed it yet but the older chrysler units had a rod that went from the throttle linkage to the transmission (maybe a cable now)...If you lengthen the rod it will increase shift pressure and give you an earlier shift.
SOURCE: won't rev past 2000 rpm
Check the computer on the car it may be programmed to run still on 2 K rpm you need to reprogram the computer on your car.......
SOURCE: i have a 2002 kia sedona that wont go over 3000
ve u checked the speed sensor....i am having the same problem with my 2002 kia sedona
SOURCE: 2002 Kia Sedona. Car wont start. We change to new
Did you check the ignition system? The module and the ignition usually at fault when u can't start the car! U have replace the ECU w/o any scanning by the dealers computer to check wuts wrong w/ ur car? That'll be a shot to the moon! Pls go to ur nearest dealer and have ur car scanned by their computer analyser! hope that might help u! taaah!
245 views
Usually answered in minutes!
×