Hey - check the repair manual: http://onlyrepairmanuals.com/downloads/hyundai-elantra-lavita-repair-manual-2001-2010/
Probably going to be in body/interior section.
SOURCE: oil change procedure on a 2005 Hyundai elantra
it is very easy to change the oil put the car on ramps secure the back end look for the drain plug underneath the engine make sure you have the right size wrench and when you remove the plug also check the gasket on the plug to make sure it is not cracked you will also need an oil filter wrench and my other suggestion to you is to go to autozone to see if they have a Haynes repair manual for your car and if they don't see if they can order you one in the mean time they can also print you off a diagram of how to change the oil in you car safely
SOURCE: need to remove rear seat of 1996 hyundai elantra
between the seats there are two bolts in the crack... you will have to take those loose..
SOURCE: change tke hood realase cable in hyundai elantra
Service and Repair Notes HOOD LATCH CABLE REPLACEMENT Remove the following items: Hood release handle. Radiator guard. Hood latch. Wheel guard. Using a clip remover, detach the clips from the body, then remove the hood latch cable (A) from the vehicle. NOTE: Take care not to bend the cable. Installation is the reverse of removal. NOTE: Make sure the hood latch cable is connected properly. Replace any damaged clips.
SOURCE: alternator removal on 2001 Hyundai Elantra
All I did was wiggle the bolt out . You have to loosen the power steering pulley and bracket and remove the fan shroud on the left side.
SOURCE: how do you take the front driver side door panel
It is pretty easy, but care must be taken so as to not damage the door panel. I recommend purchasing a door panel clip removal tool for this purpose. They are available at most parts retailers for just a few dollars. Using these tools to relaese the plastic clips on the door panel can save you a lot of aggravation and expense.
> Remove the triangular-shaped cover that covers the inside portion of the door mirror mountings. It simply "un-clips".
> Remove the screw that retains the bezel over the indide door release handle and remove the bezel.
Remove the two scres retaining the door panel to the door frame. One is under the triangle cover behind the mirror that you removed, and the other goes straight down into the pocket of the door pull.
Then use the special door clip release tool (recommended) or another suitable tool to pop the clips loose around the perimeter of the door panel. Lift out and up to remove door panel.
Installation is the reverse order.
812 views
Usually answered in minutes!
×