SOURCE: what is the fuse location for a 2007 jeep compass,
there is no turn signal fuse it is integrated with the fuse module.
SOURCE: remove 2007 jeep compass bumper cover
Hello, I can assist you. Begin by rounding up the necessary tools:
7mm socket and ratchet
7mm wrench
10mm socket
screw driver or panel removal tool (for push rivets)
Now go to the following site and take a look at the step by step instructions and pictures which does a nice job of explaining this entire job. Thanks for using Fixya!
http://www.jeeppatriot.com/forum/showthread.php?t=6291
SOURCE: 2007 Jeep Compass won't start.
reboot the computer by disconnecting the battery and reconnecting
SOURCE: No Turning signals or windshield
When you don't know which fuse is which, I would go ahead and check them all. All you need is a 12 volt test light which has a sharp probe on one end and an alligator clip on the other end. Ground the alligator clip to a piece of metal by the fuse box. Then turn the ignition switch to the on position. Then probe both sides of every fuse. It should light on both sides. If you find a fuse that only lights on one side, that fuse is blown. If it doesn't light on either side, skip that fuse as that is not the bad one (those are generally for headlights or engine components). If none of the fuses light up, check your ground or change to another ground location. You can always check to make sure your tester is working by checking it across the battery. If it doesn't light there, the tester bulb is burnt out. When you find the blown fuse, replace it with the same color/same amps. Hope this helps. Good luck :O)
SOURCE: 2007 jeep compass. compass will start, but will
yake the cover from the stik off,at passanger sideu will see a white paastic that is conected tu a valve ,falow that mecanis and you will get it to a cable that goes all the way up to your egnition ,from the egnision to tha little plasti you will find that the cable is lose or off the track
77 views
Usually answered in minutes!
×