SOURCE: Mustang GT 4.6 EVAP Canister Purge Valve Location?
You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Brett
SOURCE: Location of the Purge Control Valve for 2003 Hyundai Tiburon
There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:
And the 2.7 Liter V6:
SOURCE: how to replace a valve cover gasket 2003 hyundai santa fe
Just take a picture of it with digital camera or phone. And start removing wires and hoses until they are all out of way of cover. Then remove the bolts all way around cover and pull straight up and it will come right off. If not use a flat head screw driver to prise it off. Clean old gasket off of valvecover and engine. then put it bak together. Tighten bolts slowly, start with ones in center ov it and work your way out. Just finger tight. Then snug, then torque em down. Not too tight as if tostrip the bolt or break it off. Cause it be very expensive. also write down everywhere each wire go's unless you can remember
SOURCE: where is purge volume control valve 2001 hyundai
on the rh side on the back of the intake manifold.
SOURCE: location on 2001 dodge voyager purge control valve
Look on the passenger front of the engine compartment near the radiator. It will be mounted on a bracket, it will have two hoses attached to it, and have a single connector.
Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
735 views
Usually answered in minutes!
×