I found a method to determine calibration issues with actuator mechanisms that may be of help with your T & C -
2003 Chrysler Town Country Blend Door Actuator Locations
SOURCE: 2002 Chrysler Town and Country
Ok, i'm assuming your replacing them, there is an oval rubber stopper on the backside of the rotor, in the backing plate, located near the bottom. it will tighten or loosen the e-brake shoes inside the rotor, loosen them all the way off, then get a big hammer and give them a really good smack, be carefull not to damage the wheel studs, if your reusing them hit on the hat of the rotor, if replacing you can hit right on the rotor face.
Use some antiseize on the hub before installin your new rotors, and don't forget to readjust your
e-brake and reinstall the rubber plug
SOURCE: How do you take off driver side door panel on 2002 T@C Chrysler van?
Take off whatever screws you can find. I believe there are 2 or 3 along the botttom, 1 in the pull cup and there may be another one somewhere around the switches. Then stick a flatblade screwdriver up into the bottom between the plastic and sheet metal and pry outwards. Feel around for a plastic clip and try to pry right next to it if you can to avoid breaking the panel. Once you've got the bottom loose, just reach in there and pull the whole thing away from the door. There's gonna be a few electrical connectors and a rod that goes to the interior release handle. Don't forget to hook that thing back up when you put it back together. Those plastic clips go all the way around the door and you're gonna break a few of them. Don't sweat it though. They only cost a couple of bucks a piece and generally don't need ALL of them anyway.
SOURCE: removing and replacing passenger side mirror 2002 town and country van
there should be a triangle shaped plastic section on the interior of the door behind the mirror, check it for a little plastic screw cover to remove it or you may just have to lever it gently to remove it.
once it is off it exposes the mirror retaining bolts which you undo to remove the mirror, I presume it has electric mirrors and if that is the case you will have to find the electrical wire plug for the mirror and pull it apart, replace mirror in reverse order of removing
SOURCE: I have a 2002 town & Country and think the BCM is bad
Check all fuses under dash & under hood in fuse/relay box first.
SOURCE: 96 Town Car Blend Door won't move
sometimes a scan tool is needed to initiate blend door motor
Please see my tip at http://www.fixya.com/cars/r6235876-no_heat_fan_blowing_cold_air . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
Your blend door actuator is above the accelerator pedal. See picture below.
225 views
Usually answered in minutes!
×