U1900 FORD - CAN Communication Bus Fault
Read more: https://www.autocodes.com/u1900_ford.html
Possible causes
Faulty / intermittent ignition switch connections
CAN Bus wiring intermittently open/shorted to power or ground Faulty / intermittent connection at PCM
Faulty electrical connections at ABS Control Module
Faulty electrical connections at the instrument cluster
Poor connections at the trailer brake controller/trailer connector
Tech notes This is typically a false/intermittent code. It can occur if: Someone hooks up a scanner to the OBDII port while the ignition is on or while the engine is idling. A trailer brake system is installed improperly/incorrectly on a truck with ABS (anti-lock brakes).
When is the code detected? When the PCM, Brake Controller and Instrument Cluster are unable to communicate with each other at any time while the ignition switch is turned to the "Run" position, code U1900 sets in memory.
Possible symptoms Engine Light ON (or Service Engine Soon Warning Light) Amber ABS (Anti-lock Brakes) Light ON Wrench Light On
U1900 Ford Description The Anti-ock Brakes System (ABS) module, the Powertrain Control Module (PCM), and the instrument cluster communicate over the Controller Area Network (CAN) Bus. This is a high-speed bus communication system and is not fault tolerant, which means any type of intermittent/loose connection between these 3 controllers will cause communication to stop. When the PCM, ABS module and instrument cluster are unable to communicate with each other at any time while the ignition switch is turned on, code U1900 will set.
Read more: https://www.autocodes.com/u1900_ford.html
SOURCE: 2000 ford f250 super duty 4x4 7.3L diesel oil leak
The HPOP (high pressure oil pump) is right under the filter housing. There are 2 lines that distribute the oil to the cylinder heads. The o-rings on those fittings go out. Kit is available from Ford or International. You will need a special wrench to get to the fittings though.
SOURCE: I have a 2007 ford
No its not just a ford problem. I just had this same problem with my lights on a 99 chevy suburban. Turned out to be a little relay switch located under the dash to the left of the steering column. The repair was about $20.00 but it works well now. You can also go to a website called Auto Forum and post questions regarding auto problems that's what I did first. The Gm dealer was useless for getting any information. Good Luck
SOURCE: I have a 1999 Ford F450 super duty diesel. It
Replace the glowplug relay.Its faulty.The glow plugs stay on until engine warms up.The engine temp switch then activates the relay to switch off.So it could be the temp switch also faulty.
SOURCE: 2006 Ford F250 Super Duty,6.0 L Diesel. Turn on
the connector is wet dry it out then push plug back into the plug in to solve problem.
SOURCE: i need a fuse box diagram for a 05 ford f 250 super duty
my 2005 f250 diesel is all of a sudden not going into 4 x 4, no lights on dash now and cannot engage on wheels manually. Does anyone know where there is a fuse that operates this function that I can check?
3,836 views
Usually answered in minutes!
×