SOURCE: 1997 Toyota land cruiser prado Rz compass bearing, temperature setting, etc.
I've been resetting pajero's compasses but try to get to an area where you can do 360 degrees turns (empty car parks, ) press the reset button and make 2 complete 360 turns slowly and normally this should set the compass bearing.
Let us know how you get on. Cheers.
SOURCE: Need tire size for 1995 Toyota Land Cruiser Prado
Big tires:
1. Hard time for your drive train (clutch, cv joint, tranny, diff gears) , power steering, brakes
2. Slow acceleration
3. possible fender damage
4. turning radius problem
5. increase body roll and instability
Advantages:
1. good ground clearance
2. softer ride
3. Enhanced off-road ability
tires your planning to buy can fit into your existing rims.
My personal opinion is for you to go for the bigger tires!
SOURCE: Toyota Land Cruiser Prado (LC90) Owner's Manual (free download)
i need onwer's manual of toyota prado 2005 3.4L
SOURCE: how to check transmission oil for toyota prado
Automatic transmission is a very complicated device and its repair is costly. Most automatic transmissions must be checked with the engine running and warmed up. Also, make sure the car is on a level surface and fully warmed up.
If you not sure how to check the automatic transmission fluid, here is a step-by-step explanation:
Begin by letting the engine idle with the parking brake engaged and your foot on the brake.
Move the gear selector through each gear. This ensures that the fluid is circulating through the pumps, thereby providing you with an accurate reading.
Once you have done this, put the vehicle in park, but leave the brake engaged and the engine running.
The transmission dipstick is located near the rear of the engine. Pull the transmission dipstick out, wipe it clean with a rag, and note the markings on the end of the stick. The usual markings are “FULL” and “ADD 1 PINT”. Inset the dipstick fully and remove it again to take a reading.
If the engine is cool, it should be at the upper end of the “COLD” mark.
SOURCE: need to torque cylinder head on a toyota land
Refer to the diagram and torque bolts in sequence as shown in 3 passes. Bolt thread should be lightly oiled. Bolt holes clean of dirt.
1st pass : 39 N.m. (29ft lb)
Make a mark on the bolt with white-out/chalk or similar in the forward facing edge of the bolt.(see diagram)
2nd pass : turn bolt through 90 degrees
3rd pass : turn bolt through a further 90 degrees.
Using a mark on the bolt makes it easier to keep track of where in the sequence you are.
127 views
Usually answered in minutes!
×