In the front under the car likke metal pieces is rolling
SOURCE: Metal against metal sound
I would check the upper & lower balljoints & control arm bushings. If it has torsion bars in the suspension that could be the culprit as well. Poke a small hole in the ball joint boots & spary wd40 in there & see if the sound gets better or goes away.
SOURCE: Hello,
Here is an online guide that will help you : http://www.wikihow.com/Recharge-the-Air-Conditioner-in-a-Car
SOURCE: Whenever the car hits a
Possible sources include a blown shock, worn wheel bearing, worn tie rod end.
A bad shock can sometimes be located by bouncing one corner of the car at a time and watching how that corner settles; if released at the bottom of the stroke, the car should not do more than rise above level and drop again. Any more action points to a shock that isn't tight anymore.
A worn bearing can often be found by grasping the top of the tire and checking for play by pushing it in and pulling it out again; there shouldn't be any noise or noticeable play.
By having someone at the wheel, worn suspension points will show play as the wheel is turned back and forth at a medium pace; look for suspension points with abnormal movement and don't respond to a reversal of turn direction instantly.
The last two problems will be seen if a wheel alignment is attempted and will cause the measurements to vary from one time to the next.
SOURCE: 1996 geo prizm lsi has grinding sound in front
need to check the hub. it could be the broken bearing making the sound.
71 views
Usually answered in minutes!
×