2016 200. Why does uconnect radio turn off? - Car Audio & Video

There are a few things you can try to troubleshoot this issue with your 2013 Chrysler 300c's Uconnect Bluetooth system:

1. Make sure that your phone's Bluetooth is turned on and that it is in pairing mode.
2. Check the Uconnect system's settings to ensure that Bluetooth is turned on and that it is set to discoverable mode.
3. Try restarting both the Uconnect system and your phone to see if that resolves the issue.
4. Check the vehicle's manual to see if there are any specific instructions for pairing a device with the Uconnect system.
5. If the above steps don't work, try clearing the Uconnect system's memory of previously paired devices, and then try pairing your phone again.
6. Check if the software of the Uconnect system is up-to-date, if not update the software.
7. Try deleting all previously paired devices on the Uconnect system, and then try pairing your phone.

If none of these steps resolve the issue, it may be a problem with the Uconnect system itself and you may need to take your vehicle to a Chrysler dealership for further assistance.

Try disconnecting the battery for 5 minutes. If the radio does not come back after this "cold boot" it has failed internally. Go buy a pioneer with Bluetooth for 1/4 of the radio replacement cost.

Yes, divorce

Push the uconnect button and at the same time when the voice
says uconnect ready adjust the volume knob

Not all Chrysler products have uconnect; it may show the button on the radio, but if the uconnect system isn't installed you get the error you're getting; My Dodge Nitro is the same. You can buy the uconnect from the dealer or off of eBay (they run about $300, plus it has to be installed) Details about Dodge Chrysler Jeep Ram Hands Free Uconnect Kit OEM MOPAR

Because you have bluetoot in the radio

the button was put on the radio for future installation of a uconnect system if it wasn't ordered from the factory with it

i only recived the channels