2005 dodge durango put in dryve n it takes off slow but then fine....wat is it ??

SOURCE: egr valve dodge durango

if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.

anwar alkhaldi

• 197 Answers
• Posted on Apr 26, 2009

SOURCE: 2005 Dodge Durango

The p0300 What does that mean? Basically this means that the the car's computer has detected that not all of the engien's cylinders are firing properly.
A P0300 OBD DTC code indicates a random or multiple misfire. If the last digit is a number other than zero, it corresponds to the cylinder number that is misfiring. A P0302 code, for example, would tell you cylinder number two is misfiring. Unfortunately, a P0300 doesn't tell you specifically which cylinder(s) is/are mis-
==================================
The p0430 What does that mean? Basically this means that the O2
downstream of the catalytic converter on bank 2 is detecting that the converter is not working as efficiently as it should be (according to specs). It is part of the vehicle emissions
system.

SOURCE: reprogram 2005 Dodge Durango key fob

Go to the dealer. It is the only way, they have to use a computer. Changing the battery doesn't make it lose it's program though. You most likely broke the battery hold down. This is the most common thing I see at my shop. If the key still starts the vehicle, you now have a bad key fob. If not, you may be able to get it reprogrammed.

SOURCE: 2002 dodge durango whinning noise will your

Thank you for getting back to me. I would like you to check your transmission fluid. start the engine and let it warm up at idle speed for about 15 min and check the fluid. It sounds like you do not have enough in it, there for the whining noise with increase of speed since your transmission is speeding up with the rate of your vehicle. If this does not help and the problem persist please let me know. If the noise you were hearing was coming from the u joints of the vehicle it would not make a whining noise with increase of speed. The u joints will only make a noise when they are going bad when the vehicle is shifted into any gear from the shifter( EX: park to drive, park to reverse ECT.)

SOURCE: where do i put freon on a 2005 dodge durango 4.7.

The valve should be right on the A/C line that attaches to the compressor. Run your hand along it and see if some yahoo at the factory installed the line with the valve pointing down instead of up. It should be on the silver/metal section of the line.