The ESP (Electronic Stability Program) light turns on in a 2010 Journey when the system detects a fault or error with the vehicle's stability control system. This can be caused by a variety of issues, such as a faulty wheel speed sensor, a malfunctioning steering angle sensor, a problem with the ABS system, or issues with the traction control system. In some cases, a low battery voltage or a loose connection can also trigger the ESP light to turn on. It is recommended to have the vehicle diagnosed by a professional mechanic to identify the specific cause of the issue and perform the necessary repairs.
SOURCE: esp light comes on after long journey
Hi there:
The "ESP" system helps correct oversteer and understeer by breaking the inner or outer wheel as needed to get the car back on a straight path. When the light flashes the "ESP" system has detected this condition and has momentarily engaged.
The fault can range anywhere basically from simply a failed brake lamp switch to anything like a failed wheel speed sensor,or brake pressure sensor etc. Check first to make sure you didnt accidently push the ESP on/off button on your dash which would cause this light to come on also. If thats not the case then you will have to have the code or codes read in your ESP control module (computer) to see what code or codes are set to be able to diagnose from here.
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
SOURCE: ESP bad warning light on 2010 dodge journey
(ESP) Electronic stability program.. Enhances driver control and helps maintain directional stability under all Conditions. Provides the greatest benefit during critical driving situations Such as when driving on mixed surface conditions such like snow,ice,gravel.... You could turn off by pushing a button that has a drowning of a car with squiverly lines on it .. If that don't work plz reply back to me thank u
SOURCE: Have no power when I turn ignition on. However lights turn on an interior lights work. 2010 journey
The lights are on a different B+ circuit , ignition may turn on a relay like so many newer vehicles today . The ignition switch could be an input to the BCM - body control module ,which then the BCM energizes a relay turning on power to certain systems on the vehicle . You can check out wiring diagrams here http://bbbind.com/free_tsb.html free wiring diagrams ! I'm looking at a power distribution diagram an it shows run relay an a run ACC relay .This are none replaceable , built into circuit board it says . There is another one run start relay . These dodge vehicles have what is called a TIPM - totally integrated power module . It's a fuse / relay center with a microprocessor built in . This is under the hood in engine compartment > I know they have had problems with this ! But all so have see bad grounds under or near these , if the Battery is there too .
1,478 views
Usually answered in minutes!
×