SOURCE: Jag S-Type -intermitent fault where the remote fob does not work
This does not sound like a fob fault - but a locking control module fault , either in the hardware or software of the unit. Get it checked at a Jaguar dealers. When unlocking using the key - as soon as the door is opened you should hear a chime sounding inside the car - this is a timer counting down to sounding the alarm. If you put your key in the ignition as soon as you open the door the alarm should not go off and the chime should stop. If it does not this again points to a fault in the locking controller.
hope this helps - good luck.
SOURCE: my mk4 golf has a problem with the central
try disconnecting your vehicles battery for about 5 min[remember to have your radio code].reconnect battery and try the central locking again.
SOURCE: my renault laguna 1999 rt remote key fob wont work?
IF YOU TYPE 1999 RENAULT LAGUNA REPROGRAMME KEY INTO A GOOGLE SEARCH, YOU WILL BE ABLE TO PRINTOFF INSTRUCTIONS TO REPROGRAMME THE KEY TO THE KEY READER.THE IGNITION NEEDS TO BE OFF TO DO THIS
SOURCE: Power door locks and driver side power window not
You can do it yourself.
Couple of times when you replace the remote battery, you might have them not working/ responding but just follow the procedure below.
Stand close to the car, hold down the open and close knobs for about 10 seconds. Press them at the same time for 3 seconds; then press the open button as the car opens.
The above procedure is applicable to a lot of car brands. It does not matter how many knobs you might have on the remote fob.
I have carried this procedure out on a lot of brands ranging from Honda, Toyota, Rover, Ford, etc. and it works perfectly well.
Good luck and Rate this.
Cheers
SOURCE: Power door locks and driver side power window not working
The solution to this issue was recently discovered during our most recent trip to the shop. We told them not to leave the window down when they changed the battery... BUT DID THEY LISTEN...NOOOO.
So quite by accident I was finally able to correct and then test fail the system and test and fix again...
Here you go.;
1. disconnect the battery and connect both the positive and negative cables together(after disconnected))
2. disconnect the window and lock controller in the driver's side door.
3. Leave cables connected for at least 5 minutes
4. Re-connect door window controller and locks wiring harness
5. Place the key in the ignition and turn to the run position
6. Connect Battery starting with the negative cable(ensuring not to connect then disconnect, (one swift motion)
7. open drivers side door and turn key to the off position(do not remove)
8. You should hear a series of dings
9 Once dings are heard remove the key from the ignition and you should hear the door lock solenoids activate..
10. Congrats.. Your done and the windows and locks work.
85 views
Usually answered in minutes!
×