Whomever gave you code should told you what it is. goofle OBD codes and all them are there.
P0302 OBD-II Trouble Code: Cylinder 2 Misfire Detected
P0302 OBD II Trouble Code Cylinder 2 Misfire Detected YourMechanic Advice
Fuel injector may be restricted or hung open .
SOURCE: Check engine light comes on. p0171 and p0351 codes found
From Lusty Kid:
I know the economy is bad, but change all of the plugs. Check your PCV Valve hose, 150 rottens them out allowing air to be sucked in, thus all kinds of codes.
Depending on mileage. Dismount the EGR valve and clean passages. If you are really good dismount the throtle position sensor body and clean out passages with Choke Cleaner., dismount where the EGR valves connects to the engine, clean out passages. Also check the hose thats behind this mounting to ensure is not clogged. If clogged clean it out. If not replace it. Is about 1.5 ft. long, connects to the PCV Valve Hose.
When is the last time you change your harness. Can't remember??? Replace it. Good Luck
SOURCE: engine code p0307 cylinder #7 misfire
It could be carbon deposits on valve seats keeping valves from totally closing. You can try getting you a can of motorcraft PM3 top end engine cleaner and get engine up to operating temp then remove one of the small vacuum lines from the intake and draw the contents of the can slowly into the engine.After you have drawn in the contents shut engine off and let it soak for about 45 minutes then crank it back up and let it run until it clears. Now it will smoke like a forrest fire while you are doing this so don't be alarmed,just tell the neighbors you are spraying for mosqitos.This may cure the problem. If not you may be looking at a valve job.
This can be verified with a compression test if this is what is causing it.
SOURCE: Engine Won't Idle
Here is the common cause of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.
SOURCE: 2004 ford ranger edge has blinking check engine
have the crank sensor check for erratic operation. if you have done all of that then there is nothing else. and they way the computer knows it is misfiring (if it is) false code maybe and could be bad crank sensor. good luck
136 views
Usually answered in minutes!
Compression check is needed .
×