How to replace the right rear tailight assembly on my 2013 Highlander
SOURCE: how do you replace the rear taillight assembly on a 2009 toyota
actually, you need to remove the bumper cover as solution 2 says, then there is one screw there that you take out. but then there are 2 nuts that you have to access from inside - which they want you to take the whole interior of the truck apart to access. i have the same issue, except it was my husband who backed into our minivan,and i'm not sure what i'm going to do. if you take off the access panel, you'll see that it looks like you could almost get those nuts off if you had the right tool - a very narrow long socket and socket extender to fit in the access holes. i'll let you know if i'm able to do it or not.
SOURCE: I HAVE AN 2005 STS
you might have a bulb that is out, that you haven't changed or you've replaced with the wrong bulb or bulbs.
SOURCE: How do you replace the
remove the screws in the tail light housing. Either there will be 4 screws on the outside holding the housing, or there will be two plastic wing nuts on the inside behind the rear liner. Oce the screws or nuts are removed, then you can gently pry off the plastic tail light lens.
SOURCE: Does anyone know how to replace the rear tail
Sorry it's glued together. And you can't just buy a lens cover.
SOURCE: My turn signal is out
you should be able to twist it counterclock wise and pull and it will come out then the bulb is there, that bulb should pull out, good luck hope this helps,
69 views
Usually answered in minutes!
×