SOURCE: o2 sensors
The dealer would have that exact spec for your car. Do you have any friends who are in the auto repair business or that work at an Auto Dealership? The car you have is so new that there is no repair manual out yet to cover it. I have called Chevy Dealership Parts departments before to ask questions and it depends on the person on the other end of the line, as to weather they will give you the right info. Usually they will because it means they could sell you a part or some service work. Try calling and asking or even talking to a service writer or mechanic at a shop. You'd be suprised at what you might find out.
SOURCE: im looking for the location
it is under the t-sat housing on drivers side of engine.there are two wires going to it.so follow the top radiator hose down to the housing it will be below this.thanks for the question.
SOURCE: my chevy uplander 2007 ran out of gas. I have
Since the Uplanders have the long (front to back) skinny gas tank, with the outlet to the rear; if you run out of gas with the front/nose inclined lower than the rear, then it can take upwards of 5 to 8 gallons to get it started again. It was written up in a GM TSB. Two gallons won't start it. When the gage reads less than 1/2, it's not a good idea to park with the front lower than the rear...unless you carry a full 5 gal. refill. Thank you GM engineering.
SOURCE: Where is the crank sensor located on a 07 chevy
the crankshaft postion sensor is always located either under the harmonic balancer pully aka crankshaft pully or mounted right outside the pully if yoiu need to change it keep in mind that you will need to to own or rent a harmonic balancer pully puller and a harmonic balancer pully installer kit both you can rent both at autozone fairly cheap and get all your money back when your done
job rating from 1-10 about a 3
hope it helps if so could you please leave me a 4 thumbs up feedback thank
SOURCE: where can i find the
Hello fcdallas10: My name is Roger and I will help you. To locate the camshaft position sensor look at the front of the motor. Look at the area in front of the intale manifold and behind the water pump.You should see a sensor that bolts down into the front top of the block. This will be the camshaft sensor. The repair book says you will need to remove the power steering pump to gain access to the sensor. I would send a picture but the picture is larger than allowed to send. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger
252 views
Usually answered in minutes!
×