. It's entirely possible that a component failed. For instance, if the clutch pressure plate failed, then the clutch pedal will feel very spongy and can cause the car to slip and be very difficult to shift. If it has a dampened flywheel, and that fails, then the car may lose the ability to go anywhere. It will go into gear fine, but will not move forward. If a clutch release lever failed, it may no longer release the clutch enough to allow gear changes, though slipping would be minimal. A failing hydraulic component could also cause the clutch to fail very quickly. Based on the symptoms, I think that the pressure plate has failed, but it's impossible to say for sure without seeing the car in person. You should have a qualified technician inspect your car
Thank You for your help.
×
Need to be replaced
SOURCE: Clutch slipping on 5 speed
your clutch is a hydrolic style and adjust its self
im sorry to say your clutch is probily out again.
whas the fly whell resurfaced and a new pressure plate installed
SOURCE: which cylinder in #6 on a 2006 V6 hyundai sonata
Autozone.com says that for this vehicle the firing order is 1-2-3-4-5-6 and the set-up is 2/1 4/3 6/5 meaning that the #6 cylinder is far right on the back. It goes #1 #3 and #5 in the front and #2 #4 and #6 in the back.
SOURCE: how do I replace the switch on the drivers seat of a 2006 hyundai
interesting!... there is NO automatic adjusting control on the 2006 Sonata.
SOURCE: clutch replacement procedures for 2000 hyundai
both sides front drive shaft removal ,usual cables and whatever disconnected then pull box out ,not difficult but heavy dirty work
SOURCE: I have a 05 Kia Spectra 5 speed manual
What mileage? where does the pedal "take up". You have given no really useful information to assist.On experience I will say this. The clutch may be worn or spirngs weakened through your poor driving techniques... or it could simply have engine oil on it from a faulty rear main seal...whatever it is you should have the box out and the items inspected yes for analysis..but replace the oil seal, machine flywheel (sanding is NOT good enough and instal a new clutch kit. .
Clutches slip at every clutch change..but that is limited.... a slippng clutch during driving should always have the flywwheel machined and the work done as stated above. Cheers Tony.
107 views
Usually answered in minutes!
×