2002 Mazda Millenia Logo

Related Topics:

j
jake jacobs Posted on Jul 14, 2018

Remove valve cover on 2002 mazda millenia s - 2002 Mazda Millenia

5 Related Answers

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Mar 11, 2009

SOURCE: Location under hood for fuel pump relay on 2002 Mazda Millenia S

JUST RELEASE THE PRESSURE AT THE FUEL PRESSURE TEST PORT ON THE FUEL SUPPLY RAIL THAT SUPPLIES THE INJECTORS, IT IS A METAL VALVE LIKE A TIRE VALVE, THAT IS THE FACTORY RECOMMENDED METHOD..

Ad

Anonymous

  • 117 Answers
  • Posted on May 20, 2009

SOURCE: mazda millenia problems

here are a few problems to look out for:

Check-engine light: Check engine light comes on due to carbon buildup on the exhaust valves of 2.5L engine. (1995-02)

Engine noise: Some engines make a metallic tapping noise requiring a new friction-gear spring on the camshaft. (1995)

Headlights: The headlight drain hoses can get kinked by the aiming screws causing fogging. (1995-96)

Keys: It may be hard to turn the ignition key because the steering shaft is not positioned correctly. (1995)

Steering problems: The steering wheel may be off center requiring adjustment of the tie rods. (1995). You can also have a look at the following website where some owner have given their opinions on owning one. http://www.carsurvey.org/reviews/mazda/millenia/r68654/comments/

oscar ulloa

  • 66 Answers
  • Posted on Sep 16, 2009

SOURCE: 2002 mazda millenia mass air flow sensor

Look in the oulet air cleaner tube, it's hold by 4 nuts.

Testimonial: "Thank you so very much for your assistance. I wish i could ask you alot of other questions!!"

Anonymous

  • 645 Answers
  • Posted on Feb 08, 2010

SOURCE: What are codes P1492, P0421 & P0431 on the

po421 warm up catalyst efficiency below threshhold bank 1, 431 same on bank 2..

Anonymous

  • 1 Answer
  • Posted on Feb 19, 2010

SOURCE: 2002 Mazda millenia wont start turns but wont

every once in awhile my mazda will turn iver but wont start.. thier is no reading so my mechanic doesnt know..he said thier was no spark, and then all of a sudden it started he cant get a reading on it..this has happened to me 3 different times it will run for 3 days and then the next time it wont? is thier a sensor? that last 2 times i was driving in slusshy snow and the other day thier was alot of fog..so does it have to do with something getting too much moisture? how can i figure out what the problem is without spending alot of money?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2002 Mazda Millenia S. I would like to know the timing marks and how to get the crank to TDC?

Question edited for clarity and Madza to Mazda.
Question moved to model category.

You need cylinder 1 on compression stroke with Inlet and Exhaust valves closed. With the piston at its highest point, you have TDC.

Diagrams

https://www.google.com/search?q=mazda+millenia+s.+2.3+tdc+timing+marks



0helpful
1answer

How do you know if you need a valve cover gasket?

whenever u see engine oil dripping down from the middle of the valve cover that means the gasted is worn out or maybe crispy
1helpful
1answer

How to remove rear wheel on 2002 mazda millenia it is stucked

Simply remove all the lug nuts and get down on the ground. Kick the tire from the back, away from the vehicle. One good back kick and it will pop right off.
0helpful
1answer

Where is the fuel fillter at on this 99 mazda millenia s

MILLENIA FUEL FILTER LOCATED BENEATH AN ACCESS COVER IN THE TRUNK .ACCESS TO THE COVER IS ACHIEVED BY REMOVING THE TRUNK MAT TO EXPOSE THE COVER.
2helpful
1answer

How to replace valve cover gaskets on a 2000 mazda millenia w/ 2.3 DOHC Supercharger?

just look at the valve covers some are held in place with 6 bolts some only 3 do one at a time and keep working area clean and free of dirt n grease. clean valve cover good and have clean hands when handling gasket, and there your done just replace and bolt down , check bolts again for tightness in a couple weeks.
0helpful
1answer

I have oil in my spark plug shaft? Engine is doggy, lacks power under load.

you have to remove your valve cover and change the cover gasket and spark plug grommet (this is a kit) which are under your valve cover.
0helpful
1answer

I am getting the smell of oil in the interior of my 2002 Mazda Millenia. The front valve cover appears to be leaking oil.Is this a tough repair job?

It shouldn't be bad. Most valve covers are just a matter of taking it off, scraping off the old gasket material, apply a little gasket sealant gunk, put on a new gasket and tighten it back down.
5helpful
2answers

Location under hood for fuel pump relay on 2002 Mazda Millenia S

JUST RELEASE THE PRESSURE AT THE FUEL PRESSURE TEST PORT ON THE FUEL SUPPLY RAIL THAT SUPPLIES THE INJECTORS, IT IS A METAL VALVE LIKE A TIRE VALVE, THAT IS THE FACTORY RECOMMENDED METHOD..
0helpful
1answer

The lifters on my 95 mazda millenia are bad

i you remove the valve cover if you move the rocker and some got more play then others they need to be removed first run the engine and try to hear were the noise come from let say you hear noise on the driver side so our problem is in those lifter good luck pierre
Not finding what you are looking for?

71 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...