SOURCE: Hard to get my tucson in gear
Check you have no air in the clutch fluid.Bleed the system.If that does not cure the problem then if you have good pressure at the pedal you pressure plate is faulty.Then the only solution is to replace the clutch.
SOURCE: My mechanic is having trouble locating the
hi,
i have attached the image, showing the position of crankshaft position sensor.hope its helpful for you. Please rate my solution as helpful.have a great day.
SOURCE: Having trouble removing the rear
you can only get a replacement wiper blade from a hyundai dealer .because the centre pin is thicker than a normal blade and when you get a replacement all you do it just hold the plastic rear wiper housing and pull the old wiper blade out then push the new on back home and your done
STRAKER1999
SOURCE: where is backup light switch located on 2006
You didn't say if this vehicle was Automatic Transaxle or Manual Transaxle. No need
here are two photos: One is Manual, the other is Automatic. The manual trans has a separate switch (all by itself), however, the automatic (of both the 4 cylinder and 6 cylinder) use the trans range switch to provide power to the back up lamps
Hope this helps
SOURCE: 2005 Hyundai Tucson v-6 4wd.
There are several dozen codes to the engine emissions system. From minor (gas cap loose) to major (ECM failure) Some senosrs can be bad and the engine runs fine, but you can loose 10, 20% fuel economy. You need to have the codes read. parts store do it for free. But don't buy a part just for the code. It could be something else causing the code to pop. Let me know.
242 views
Usually answered in minutes!
×