SOURCE: 2003 ford crown vic hard steering
i would have to say to check for a relay in your fuse boxes for power steering pressre switch or it may have its own police pkgs have a lot of relays due to all the extras
SOURCE: door panel
Depends on what door trim you are trying to replace. If you are trying to replace the door trim on the front doors you need to remove two screws from behind the casing around the door handle and then remove a screw from the bottom left of the door and then there will be a screw on the left of the door as high as the arm rest on the door. Finally pull up on the door panel and out to remove the panel. Remove the harnesses and you are complete.
If you are trying to remove the rear doors you need to remove a screw from the bottom of the door again near the left side then remove the screw from behind the casing that surrounds the door handle. Finally pull up on the door panel and out to remove the panel. Remove the harnesses and you are complete.
SOURCE: 2001 crown vic keeps burning 30A PCM relay fuse
have fuel pump checked i have known a bad fuel pump shorting out causing pcm fuse to blow.
SOURCE: Location of fuel pump relay on a 2001 Ford Crown Vic
where is the fuel pump relay on a 2001 crown vic p71
SOURCE: 1994 ford crown vic front pass. side power window regulator...
Yes it is. They will need to be drilled out. Thats the best way, some people try to put bolts on, but I dont advise it.
95 views
Usually answered in minutes!
Thanks i have replaced a lot of elet.parts own it i will let you no
×