How to adjust the headlights on a 2003 Oldsmobile silhouette

SOURCE: 2002 Oldsmobile Silhouette ABS Light is on and

The first thing i would check is all 4 abs sensors at the wheels.You can do this with a volt meter set on ac voltage and spin the wheel if it generates voltage at all on the meter its good.

Drew Z

• 681 Answers
• Posted on Feb 27, 2010

SOURCE: How do you change a headlight on a 2001 oldsmobile

I don't know if you mean the headlight bulb, or the headlight.

When you open the hood and look at the headlight assembly. At the top between the turn signal there is a black plastic wing nut. Unscrew that wing nut to remove the side marker light. After removing that nut persuade it to slide forward. That's the only thing that locks it in. Untwist the socket to replace the turn signal bulb. Since that is out now...There are two more Wing nuts just like the first one that hold the headlight assembly in place. (The black plastic piece the headlight is mounted to) Remove these two wing nuts and lift up on the whole assembly. Those are the only things that lock it into place. Once you slide it off the studs the wing nuts were on. Unplug the plug from the back of the light (use a flat screwdriver to lift the tab a little). Twist the round plastic ring that holds the bulb in. The bulb should pull out now. Don't touch the new bulb with your fingers as it is a halogen bulb and the oil on your fingers will cause a hot spot on it, causing it to fail SOON. If you happen to touch the glass part of the headlight bulb, clean it with rubbing alcohol. Reverse the steps...go eat dinner.

SOURCE: 2003 Oldsmobile Silhouette. Parked van went into gear on own

Please have a dealership that handles GM vehicles check to see if your vehicle was involved in what the trade considers a run away transmission condition involving the automatic transmissions parking pall linkage defecting thus allowing the transmission to go into drive while the vehicle is idling in park.

Testimonial: "Thank you very helpful. "

SOURCE: location of the lower pressure

One cap is labeled "H" (for high pressure) and the other is labeled "L" for low. As a further safety measure, the ports are different sizes so you physically cannot attach the pressure gauge or hose to the wrong port! It's pretty failsafe. follow a/c hoses back from pump and you will find it, its cap is marked " L ". ( low side ). have a good day !!

SOURCE: How do you change the

you have to pop the hood and get behind the headlights and remove the nuts