I have a 02'highlander and had a bulb bust on my boat trailer. Ended up melting my harness that hooks my tail lights to the trailer T-style?lol anyway the block that has all the wires running into it.And ever since then i have replaced the harness and now have no running lights on car but all other lights work.
SOURCE: 19" FACTORY TOYO TIRES SHREDDING
Toyo®, Exclusive Tire of 2008 Toyota Highlander Hybrid, Limited Grade
September 20, 2007– CYPRESS, CALIFORNIA – Toyo Tire (U.S.A.) Corporation announced today that the Toyo® Open Country® A20 is the exclusive tire of Toyota’s all-new 2008 Highlander Hybrid, Limited grade. In addition, the Open Country® A20 is original equipment on several other models of the 2008 Toyota Highlander, both hybrid and gas.
The Open Country A20 achieved exceptional low rolling resistance performance making it ideal for the hybrid model. The tires were also specifically designed to reduce noise and improve both wet and dry braking for added safety.
Based on the model and trim level of the Highlander, the Open Country A20 comes in two sizes: P245/65R17 105S and P245/55R19 103S.
Toyo manufactures and distributes a complete line of replacement tires for high performance cars, luxury vehicles, light trucks and SUVs as well as tires for commercial trucks, buses and off-road and construction applications.
I'm surprised if it's so good at braking that it has not ripped my entire tire tread off as technicians say the treat is separating well before its time!
SOURCE: 2002 Toyota Highlander Cracked Tail Light
Inside your trunk on either side of your tailgate are panels that allow you access to your taillights....I'll add more later.
SOURCE: oil burning in my 2001 toyota highlander 84000 miles. bad rings.
You need to talk to a dealer.
SOURCE: 2003 Toyota Highlander.The brake light on the
Replace the right rear brake lamp. The bulb possible use two filaments one for brake and tail light. One burnt out filament in one bulb.
SOURCE: How do you replace the
remove the screws in the tail light housing. Either there will be 4 screws on the outside holding the housing, or there will be two plastic wing nuts on the inside behind the rear liner. Oce the screws or nuts are removed, then you can gently pry off the plastic tail light lens.
66 views
Usually answered in minutes!
×