Where is the dip stick housing located on the mk1 land rover freelander L series 2.0 di

SOURCE: HOW TO CHANGE THE TIMING BELT ON A 2002 LAND ROVER FREELANDER

Engine ?

SOURCE: Land Rover freelander hill decent

The hill descent switch wires have broken off on the switch.Pull down the gear lever cover and remove the micro switch ,solder the wires back on and refit.

SOURCE: Fuel Filter in Freelander (replacing)

The fuel filter is located below the electrics box, half way between the battery and the bulkhead on the passenger side, under the bonnet. It is very difficult to see how it all fits, but it has a central screw which holds the plastic filter housing/mounting in place. Find this screw (which is a small self tapper) and be prepared to loose it, or use a magnetic screw driver. Then lift the plastic housing up and away, (towards the engine) be ready with loads of rags to catch the diesel fuel when you disconnect the pipes. There is an earth wire attached to the housing also. (anti interference, I think) It is quite a fiddle getting it back again, as it has two locating lugs on the back of the plastic housing/mounting.

SOURCE: 2002 Land Rover Freelander radiator and air fan not working

there is a module mounted on the fan shroud that is a common problem. but as always, check fuses, connectors and grounds!

SOURCE: Freelander chassis number

under the passenger side-frame rail near the front tire