SOURCE: 2003 chevy silverado will not shift into drive or overdrive.
transmission shift solenoid is stuck open this is a common vehicle issue in automatics and not particular to any make or model vehicle 15 dollar part and arm and leg for labor if taken in
heres an idea to try
take out the transmission filter and replace with new one make sure to take not of any metal debry in trans pan this indicates the trans had sheered its gears down and a trans rebuild is needed
the transfilter needs to be changed at a certain milage interval they can get clogged up
there is a kit you buy for your truck at any parts store
its an easy change hour of time unbolt trans pan unbolt trans filter and put new one in
kit comes with new seals less than an hour you can do it yourself
to overdrive you would feel a difference in shift badley if it was that something to keep in mind
SOURCE: overdrive contoll button is blinking on 200 f-350 7.2 powerstroke
It sound is if your ABS/Speed sensor is the culpret. Try this fairly inexpensive repair before you bring it in for a Diagnostic, which can run anywhere from $89.95 & up. Go to the local ford dealer in your area and ask them for the ABS Sensor in your rear axle differential. The base part number being 9E731. This part runs roughly for about $20.00+ and your own time to replace it.
SOURCE: will not shift into overdrive
There is an electronic sensor on the outside of the transmission.Change the filter and fluid and replace sensor.The sensor costs around $150.
"High speed" probably is over drive,so if it is turned off,it can't engage.I have found that cutting the overdrive switch on and off can cause excessive wear and tear on the overdrive.
Regardless have the car scaned for a any codes thay is causing the problem. Just trying to keep the cost of repairs down by know exactly what the ECM has in it's memory for any malfunction that is creating your overdrive from engaging.
Good luck and hope this helps
SOURCE: what cause overdrive light to come on while
This is like a check engine light for your transmission. Something is slipping or out of its values. Get it checked out with a code reader.
SOURCE: 2003 Ford Focus: Pulls Codes P0751, Shift Solenoid
Hi. I have Ford Focus 1.6 auto. Was a problem with a gear box. First one was faulty, so changed to secon d hand one. Once I change it it stops shiftin gears and the car jumps then I shift to drive or reverse. Fault codes was shift solenoids and pressure solenoid open circuit. I changed another gear box, the same problem, just faulty code is pressure solenoid open circuit.Could you tell me where is a pressure solenoid based or could it be ECU fault?
80 views
Usually answered in minutes!
×