Cars & Trucks Logo

Related Topics:

K
Kaye Wyatt Posted on Jun 11, 2018
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Gate opener hit by lightening or a surge Wed. Gate will not open. Code on the opener says 72 which means there is an obstacle obstructing the gate but there is none. What part needs replacing?

1 Answer

Robert Wood

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Cars & Trucks Master 6,140 Answers
  • Posted on Jun 11, 2018
Robert Wood
Cars & Trucks Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Oct 21, 2014
Answers
6140
Questions
3
Helped
1190324
Points
20142

The obstacle sensor whether an photo sensor or pressure sensor may have burnt out.

5 Related Answers

Anonymous

  • 7 Answers
  • Posted on Sep 30, 2008

SOURCE: chevy blazer 2w drive 2 door-rear gate wont open

you will need to try to remove the rear door panel on the tail gate or pry it away its not easy because of hidden screws the manually pull the linkage

Ad

Anonymous

  • 1 Answer
  • Posted on Oct 25, 2008

SOURCE: Rear window and gate will not open.

This is only part of a solution or suggestion. I have the same problem and the car manual says to reach under the tail gate, inside under the carpet and there is an emergency release. I can't find it. It says you need a screw driver or sharp skinny object to do this. Good luck hope you find it. Hope you have your manual.

Anonymous

  • 1 Answer
  • Posted on Aug 13, 2009

SOURCE: rear tail gate will not open

how to i open a stuck lift garte on a ford winstar 2000 lock broken too

Anonymous

  • 11 Answers
  • Posted on Aug 14, 2009

SOURCE: 1997 Grand Cherokee. Tail gate wont open. Handle

These rear hatches have a cheesy rod and clip setup. You have to remove the panel from inside, you have to loosen the screws around the hatch and pull it away and reach in down toward the latch and open it that way so you can get the 2 screws out of the bottom easier. There is a peice of plastic in these that's a dust barrier, try not to tear it up too badly, and when you go to put it back, I use a spray adhesive to stick it back on while I put the panel back on. after you get it open you will see a rod with what looks like threads hanging there attached to nothing, and a little thing that has 2 notched areas and a clip to hold that rod into those 2 notches. bend the clip down to make it tighter and then force the rod back into place that should fix your problems. If that's all in place then it's the latch mechanism, usually they can't be fixed because parts aren't available, just have to buy a new one and put it in.

Testimonial: "Thanks very much, I'll give it a try. It's a bugger getting the inside panel off, I tried a few times unsucessfully."

Anonymous

  • 430 Answers
  • Posted on Nov 23, 2009

SOURCE: rx330 won't open rear gate

Inside the glove box on the left side there is an on/off switch, which m,ay have been bumped off thereby shutting off the power controls to the hatch. Check that first. Then press the unlock button on your key twice, then test all 3 power hatch buttons to test them, one each on lower left dash by the gas cap door release, one on fob and the one at the hatch. If they still do not work it is possible your door may need to be 'initialized" by your dealer due to power failure. I have seen this with seats and windows but never with the rear door....

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to adjust open close limits on a 4 meter gate for a Germin motor

on the shaft that controls the arm or gear for the gate movement there will be 2 cams
open the gate and then loosen of one cam and adjust it off the micro switch until the gate is fully open
lightly tension the screw and then close the gate
repeat the adjusting on the second cam until the gate is fully closed
tension up the screw and then using the remote open the gate when it is fully open leave it or in it is not make small adjustment to get it open
press the remote to close the gate and again adjust to properly close the gate
0helpful
1answer

Gate beeps when turned on and opens on its own mighty mule dual gate

There are limit switches that set the open and closed position and also a sensor for obstructions. Check those items for shorts and proper connection
1helpful
1answer

2006 KJ Cherokee 2.8lt turbo diesel manual. When I accelerate engine surges then flat spot then surges again as it accelerates there is also a lot of black smoke coming out of the exhaust pipe

There is a waste gate on a turbo and that gate dumps the excess pressure in the manifold. There is a sensor that determines when the gate opens and closes. You need to run a diagnostic scan and see what the waste gate and sensors are doing.
0helpful
1answer

Sliding gate pauses and shakes when it first starts, both opening and closing. Does this for a while, going very slow, then smooths out and closes and opens ok.

most sliding gates suffer form dirt, grass , rocks in the gate track so constant cleaning of that track is essential
small twigs , rocks will slide along with the wheels on opening but are an obstruction for the wheels on closing
most closing gates run a cog and rack system at the bottom ot the gate so check that the mesh of the rack and cog is correct at either end
0helpful
1answer

Toyota 4runner Lift Gate Won't Close/Open

Insert the key and turn the lock cylinder while lifting up on the lift gate. You have to get the gate open. Once open, The strike plate (where the locking mechanism hits) is bolted to the jamb. Loosen the bolts and slightly move it toward the rear of the vehicle. NOT TOO MUCH!
Tighten the bolts, and try it. Hope this helps.
0helpful
1answer

Can I open the rear glass when the gate is open. I have a large item that needs to get into the car via the gate, but I only need the window open after that. If not ... how do I get it done (forcefully)...

You should be able to open the window and the gate. If the window won't open while the gate is open, try opening the window first, then opening the gate.

Good Luck!
~Brandon
6helpful
2answers

Back door wont unlock

I have a 1999 Chrysler T&C 3.8 liter like yours and it sounds
like you are having the same the same problem I had.
Every time you hit the door unlock or lock button, it made a loud
buzz like you just missed a question on a game show. ;-)

It turned out the problem was the rear lift gate lock actuator. The part costs
about $40 from the dealer if I can recall correctly.

The repair involves: 1st removing the middle and rear seats to get
access from the inside to the rear gate
(obviously you will have to remove the seats from the side doors
since the rear gate won't open yet)

Remove the plastic inside rear gate panel and molding (phillips screws)
Once you remove the panel, you may see a way to manually
open the rear gate. As I recall, I think there was a access opening
covered from the inside with a black weather/insulation tape.
Carefully removing this out of the way gave access to a way to
manually open the gate, making the rest of the work easy.

Remove the electrical connector and the mounting bolts
to remove from the actuator. It is attached to the inside
rear gate with 2 or 3 bolts (10 mm?)

Remove the old one and replace the part, then put it all back
together, make sure you reconnect the electrical connector

Takes about an hour for the whole job (max)

Hope this helps,

Wes
1helpful
1answer

What is the gate open warning light mean

that means that your rear door isnt shut all the way or swith that sends the singnal to the dash light is bad.
Not finding what you are looking for?

46 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...