Cars & Trucks Logo

Related Topics:

R
RonM Posted on Jun 09, 2018

2005. Where is reverse relay located?

My reverse lights don't work. brake lights are dim. cruise control doesn't work with the lights on. Cruise control will function normally with the lights off, however, when i use the blinker, it's turns off.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jul 19, 2008

SOURCE: horn,airbag light,cruise control

ON CERTAIN MINIVANS, THE DRIVER'S AIR BAG MAY BECOME DISABLED DUE TO A FAILURE OF THE CLOCKSPRING, WHICH IS LOCATED IN THE HUB OF THE STEERING WHEEL. Consequence Summary: THIS CONDITION WILL MANIFEST ITSELF THROUGH ILLUMINATION OF THE AIR BAG WARNING LAMP, AND COULD EVENTUALLY RESULT IN A DRIVER'S AIR BAG OPEN CIRCUIT, IF THE PART IS NOT REPLACED IN A REASONABLE AMOUNT OF TIME. Corrective Summary: DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY ON ALL COVERED VEHICLES WITH 70,000 MILES OR LESS. FOR THOSE VEHICLES WITH MORE THAN 70,000 MILES, DAIMLERCHRYSLER WILL OFFER AN EXTENDED LIFETIME WARRANTY UNDER WHICH IT WILL REPLACE THE CLOCKSPRING AT NO CHARGE IF IT FAILS. DAIMLERCHRYSLER WILL ALSO REIMBURSE OWNERS WHO HAVE PAID TO HAVE THE CLOCKSPRING REPLACED ON THEIR VEHICLES. THE RECALL BEGAN ON OCTOBER 12, 2004. OWNERS SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403. A malfunctioning clockspring can also effect your cruise control,radio, wipers, and your horn relay. This can also happen one at a time til none of these are working.The solotion is to get the clockspring replaced . I DO NOT suggest you doing this on your own!

Ad

Anonymous

  • 1 Answer
  • Posted on Sep 16, 2008

SOURCE: Cruise control does not work

On my 05 Wrangler Unlt'd Ruby - The vacuum hose on the drivers side of engine had come off, which disengaged my Cruise and the actuator which determines whether my heater points to the vent, Defrost or feet. Put it back on and secure with a cable tie.

If it is like mine, you will then have idling problems, especially when coming to a stop. You will need to clean the throttle body because the engine has picked up **** through the open port while it was off. Directions for that exist on this site elsewhere.

All of these are easy - i hadn't worked on a car in >25 years and it took me 30 min.

A

Anonymous

  • Posted on Sep 29, 2008

SOURCE: cruise control doesn't work

does cruise show up in led when you start engine

Anonymous

  • 512 Answers
  • Posted on Nov 13, 2008

SOURCE: 2005 Jeep Wrangler Cruise Control

no fuse ...sounds like the switch may have gone bad

Anonymous

  • 51 Answers
  • Posted on Mar 16, 2009

SOURCE: 1998 dodge grand caravan cruise control not working

does the horn work and is the air bag light on because if thats the case you have a bad clockspring. and for your year van i do belive that is a lifetime recall. hope this helps.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Fuse location for cruise control

Since there is no throttle cable, there is no "cruise control" fuse. The fuses used are #7, 9,and 13 in the under hood fuse/relay box and #18 in the under dash fuse/relay box. The most common failure is a bad brake pedal switch. Does the cruise control main switch "on" light work when the switch is pressed? The gauge control module (instrument panel) and the PCM control the cruise control.
3helpful
1answer

CRUISE CONTROL WON'T WORK ON 2005 CHEVY TRAILBLAZER

check cruise control fuse and check the brake lights see if brake light working because the brake light switch will deactivate cruise control when brakes is applied.if brake lights dont work either fuse blowed or switch bad.if all is good have vechicle code scan because cruise control control by PCM and vechicle speed sensor and thottle actuator control motor.
0helpful
1answer

2001 Dodge Ram 3500: brake lights don't come on, switch has been replaced and installed to instructions, turn, four ways, parking lights and cruise control interrupt all work. Is there a brake rel

have you checked wire harness @ rear of truck ? and along frame rail, ? and condition of the rear taillight assymblies, ? corrosion could be in these areas. check all ground wires also, not sure about relay ! don' t think so ! why would brakes need one ?
0helpful
2answers

2005 chevy trailblazer - no cruise control and brake lights only work when key is turned off

I would check the turn signal switch. The cruise and turn signal are on the same switch. The brake lights go through the switch before going to the brake lights. And the turn signals don't work with the ignition off.
0helpful
1answer

Cruise control not working

The adjustment of the brake light switch or it could be bad. the brake lights can work fine and the part of the switch that works the cruise doesn't The swiches that control it from the steering wheel can losse connection in a part called the clock spring. Vacume connections can effect the cruise but yours is likly cables less therefore doesn't work the cruize.
0helpful
1answer

Cruise control doesn't work on my lexus

cruise control best let garage check out,here are few things to check,check fuse and check to see if brake lights dont work.check brake light fuse if fuse okay brake light switch could faulty or bad connection then brake light will reset cruise control you apply brakes.if all is good problem could be speed sensor or accelerator pedal to ecm.you need diagnostic euipment to troubleshoot.
2helpful
1answer

2005 Chrysler town&country cruise control stopped working

Does the cruise control lights come on when you select it? If it doesn't then you may want to check the fuse(s) that give the system power. If the fuse is blown then try replacing it. If it blows again when you try to use the cruise control then the unit it self may be bad and need replacing. You can find the fuse box location and the right fuse for it in the owners manual of the car.
1helpful
2answers

Cruise control relay

There is a switch next to the brake light switch. It is actuated by the brake pedel. On the brake pedal there is a little urethane/rubber bumper. If that is gone then it will appear to the switch that the brakes are pressed. Any chance you found some rubber parts on the floor under your brake pedal?m On my 92 SE-R I found this urethane material and did not know where it came from. Then I noticed my cruise did not work. Then I noticed that my brake lights were staying on. I found these two switches (brake and cruise) were not making up because the rubber bumpers were gone. relay is located under the hood on the drivers side
0helpful
1answer

2002 Hyundai Elantra GLS: Cruise control stopped responding. Brake lights are working. What do I do to fix the problem?

It could be something a simple as the cruise control switch(s)... or it could be the Cruise Control Module located in the engine compartment. There's also a 'clock spring' in the circuit between the steering wheel & the cruise module. Note: there are two sets of contacts in the brake lamp switch, one set for the brake lights, the other for cruise control. Properly diagnose the 'CAUSE' of the problem. Otherwise you could end up buying parts you don't need. Proper diagnosis is a 'hands-on' activity, which is nearly impossible to achieve here under the FixYa website

ghost45_39.jpg
ghost45_40.jpg
ghost45_41.jpgghost45_42.jpg
Not finding what you are looking for?

187 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...