SOURCE: dodge intrepid 2003 power steering resevior has hole in it
there are 2 bolts that hold the reserviour on the vehicle once you remove those bolts you will need to take the hoses loose they should unscrew and then you can put the new one in the bolts are at the top and bottom of the reseviour
SOURCE: 1993 ford f 250 diesel wont start ?
spray silicone spray while cranking until you can get the air out of the fue line it will run on silicone spray
SOURCE: replacing the power steering pump?
Go to the autozone website at autozone.com and register your vehicle. It's free and you will have access to an online repair manual for your vehicle. The procedures for replacing the power steering pump for your car is there. ( I checked) Hope this helped and best wishes.
SOURCE: I have a 1993 F-250 4x4 speedo stopped working and
Hi I just thought you might like to know that the VSS sensor(vehical speed sensor) on a 93 f250 is actually on the top center of the rear differential. It is basically a proximity type sensor not the old school gear and cable. It will take a 1/2" or 13mm wrench I believe to remove the single bolt holding it in and the it pulls out. I think they are around 25 bucks so it's cheap enough to fix the speed sensor.
SOURCE: Looking for transmission fluid and
Heres an a pic that will help. The transmission has no reservoir, but has a dip stick. This is also the location for adding transmission fluid. You must use a very slim funnel.
296 views
Usually answered in minutes!
×