SOURCE: 2004 CHEROKEE, WONT RECONIZE DRIVERS DOOR OPEN,
its the ground wire for the driver door, and posably an ornge one, in the black shielding to the door they rip all the time but yet for some reason jeep has yet to make a recall. any who you disconect the battery then pull the shielding back and patch the wires together.
SOURCE: 1997 Jetta Drivers side door will not open.
One thing... If your last 3 doors works fine it's mean that problem is only in your drivers side. In VW like nickalxjoe wrote is air pump. So there might be an air leaking which you can hear. So if you can hear from where air running out try to fix this first.
SOURCE: the driver side door lock broke on my 98 jetta door want open
according to my partsman (who has had great advice for many years), you do not have to remove the door panel to replace the door handle which contains the cylinder lock. the handle is released with a screw which you can see when you open the door. you will need a starhead screwdriver or socket. A new handle costs around $40 at a parts store in my area. call around for a locksmith who will re-key your key to the new lock or use the key which comes with the new lock, your choice. i am in dealing with this also
SOURCE: my driver side door wont open how do i get it
sounds like the door lach is sticking
use some wd40 spray the lock and let it sit 4 a while
now since you have the inside skin off reach inside the door with 1 hand and try and open the door from the outside and see if the lock bar moves it usualy pushes down i think on a lach
if it goes up and down with no resistance make sure it is contacting the lach if yes make sure the door is unlocked
somtimes the lock is just stuck
after unlock open the door
push down on lock bar attached to lock then pull up on it if that fails to open door
after that all fails unlock door have friend pull handle and then give the door a good kick from inside just remember not the kick the glass
SOURCE: Low Beam Drivers Side doesn't work ... low voltage,
Power for the headlights on the Left side (High and low beam.) comes from the same fuse... The ORANGE wire and the ORANGE/BLACK are the same, they connect in the harness. If you only lack the 12v to make the light work connect them at the headlight assembly.
If your low beam also lacks ground the Left low beam ground is shared with the right low beam ground... Run a wire from left low beam DARK BLUE to right low beam DARK BLUE/WHITE.
If its not working now then your cursed, seek a witch doctor.
Trouble Code: P0340
No Camshaft Position Sensor Circuit Failure
Possible Causes:
CMP Sensor connector is damaged, open or it is shorted
CMP Sensor signal circuit is open or shorted to ground or to battery voltage or 5v supply circuit
CMP Sensor 5v supply circuit is open or shorted to ground or to battery voltage
CMP Sensor ground circuit is open
CMP Sensor is damaged or has failed
CKP Sensor is damaged or has failed
PCM has failed
90 views
Usually answered in minutes!
×