Had it checked at Auto Zone because of engine light on. Codes given: C0561 - P0101 - P0171 - P0201 - P0300 - P0301
SOURCE: 2000 Lexus RX300 6cyl 3L VVT-i "Engine Codes"!
The first and last code are your start and stop so you can ignore them the P1130 and P1150 are your two front oxygen sensors( pre cats ) bank one and two. Depending on your millage it sounds like it is time for a little maintence. Normally they should be changed at or around 60,000 kms
SOURCE: 98 E-250 Rough Idle; codes p0156,p1131,p1151,p0301,p0171,p0174+
po301 thru po306 all misfire codes cylinder 1-6 remove plugs and replace them..... set the plug gap first
i suggest u replace the wires also if they never been replaced all these misfire codes can set the others and one is for the oxygen sensor ( 02s or HO2S) CIRCUT MALFUNCTION do u know how to check wireing systems
do the tune up plugs (set gap) .052-.056 change the fuel filter also. clear the codes hows it run
this info is for 98 E-250 4.2Litre
what engine do u have 4.2L or 4.6L i know it is a v-6 by the codes
SOURCE: P0301 fault code #1 misfire- warning lights
Hi, I'd focus just on that cylinder for now, unless the other lights come on again. This ought to give you enough information to start diagnosing the problem - http://www.obd-codes.com/p0301 - good luck!
SOURCE: My C230 Mercedes has check engine light on. Car
P0171 indicates a lean condition. The most common cause of this is a defective mass air flow sensor. Also check if any vacuum leaks.Replace MAf sensor,if cleaning the MAF does not help.
Thanks.
SOURCE: oo dodge durango is flashing
P0201?? Injector #1 Ctrl Circ / P0300?? Multiple Cylinder Misfire
P0207 Injector #7 Ctrl Circ /
P0301?? Cylinder #1 Misfire
P0307?? Cylinder #7 Misfire
are the codes start with the basics inspect plugs wires cap rotor and if all checks out do a compression test
864 views
Usually answered in minutes!
×