Question about Ford Cars & Trucks

1 Answer

Have a ford five hundred 2005 changed the thermostat and have air in the system how do i get it out ?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 5,274 Answers

NOTE: The addition of Cooling System Stop Leak Pellets, darkens Motorcraft Premium Gold Engine Coolant from yellow to golden tan.

  1. Fill the degas bottle with the correct engine coolant mixture to the degas bottle seam line.
  1. Install the pressure relief cap.
  1. Remove the retaining clip and the fill tab on the top of the thermostat housing and fill through the thermostat housing until full.
  1. Install the fill tab and retaining clip.
  1. Select the maximum heater temperature and blower motor speed settings. Position the control to discharge air from the A/C vents in the instrument panel.
  1. Start the engine and allow it to idle until engine reaches normal operating temperature. While the engine is idling, feel for hot air from the A/C vents.
  1. CAUTION: If the air discharge remains cool and the engine coolant temperature gauge does not move or the low coolant light comes on, the engine coolant level is low in the engine and must be filled. Stop the engine, allow it to cool and fill the cooling system.Run the engine at 3,000 rpm for 10 minutes. Hot air should discharge from the A/C vents. The engine coolant temperature gauge should maintain a stabilized reading in the middle of the normal range, and the upper radiator hose should feel hot to the touch.
    • Shut the engine off and allow it to cool.
    • Check the engine for coolant leaks.
    • Check the engine coolant level in the degas bottle and fill to the seam line.

Posted on May 15, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 2 Answers

SOURCE: 2006 Ford Five Hundred -- Where's the fuel filter?

right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.

Posted on Mar 16, 2009

Anonymous

  • 1 Answer

SOURCE: I have a 2005 Ford five hundred and the

You need to have the transmission serviced. The wrench indicates that the fluid in your transmission is out of spec or you have an out of spec pressure condition.

Posted on Oct 12, 2009

Anonymous

  • 108 Answers

SOURCE: IS THERE ACTUALLY AN AUX PLUG FOR MP3

The plug is actually at the rear of the set.remove the radio and connect an audio cable

Posted on Feb 02, 2010

Harry Presley

  • 193 Answers

SOURCE: 2005 ford five hundred

If the check engine light stays on when your engine is running, your onboard computer has detected a fault in your emissions system. You need to have it hooked up to a code detector to find out what the problem is. If you are near an Autozone or Advance auto parts store they will usually do that for free. Here is where your search begins. Most of the time the code for "engine lean" will show up. That means you are getting too much air into the intake manifold. Excess air gets in through vacuum tube leaks, intake gasket leaks, faulty EGR, and PVC valves and sometimes valve stem seals, There are also a variety of other codes that may indicate faulty oxygen sensors, catalytic converter, fuel evaporative system. It is too expensive to just start changing parts and hoping you get it the first. It is important to get the codes that are stored in your onboard computer first.

Posted on Sep 20, 2010

InnvestYourS

  • 1 Answer

SOURCE: CLICKING NOISE FROM RIGHT DASH

Air/Blend Door Actuator Modual is defective: See info below
Description : Temperature Actuator Attributes : Controls the blend of hot & cold air Make : Ford Brand : Dorman - OE Solutions
Application Notes:
Please select Detailed Applications
for Application Note information. 604-203-007.jpg

Posted on May 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the pcv valve locate on a 2005 Ford Five Hundred?


It should be on the top of the rocker cover with a hose which goes to the air cleaner. Small plastic valve with a right angle bend that the hose attaches to.

Oct 15, 2016 | 2005 Ford Five Hundred

1 Answer

Where is the speed sensor located?


    2005-2007 Ford Five Hundred Speed Sensor - JC Whitney

    www.jcwhitney.com/2005...ford-five-hundred/...speed-sensor...speed-se...
    Shop for a 2005-2007 Ford Five Hundred OE Replacement Vehicle Speed Sensor by Motorcraft with a 30-day Satisfaction Guarantee at JC Whitney, America's ... images for 2005 Ford Five Hundred Where is the ...

Nov 26, 2015 | 2005 Ford Five Hundred

2 Answers

Why won't it idle above 1000 rpm?


no supposed to idle higher than that , usually even less .

Sep 24, 2015 | 2006 Ford Five Hundred

1 Answer

How do i replace rear plugs on 2005 ford five hundred ?


Jack up the car, put it on jack stands and then slide under it.

Sep 11, 2014 | 2005 Ford Five Hundred

2 Answers

CLICKING NOISE FROM RIGHT DASH ON A 2005 FORD FIVE HUNDRED?


Air/Blend Door Actuator Modual is defective: See info below
Description : Temperature Actuator Attributes : Controls the blend of hot & cold air Make : Ford Brand : Dorman - OE Solutions
Application Notes:
Please select Detailed Applications
for Application Note information. 604-203-007.jpg

Mar 14, 2011 | 2005 Ford Five Hundred

1 Answer

Can a Mass air flow sensor cause A 2005 Ford Five Hundred to not start?


Yes it can. The mass air flow sensor if your vehicle is equipped, will not tell the ECM the amount of air or temperature of air coming into the engine. Is the check engine light on? if so did you get a DTC for this Component.

Feb 06, 2011 | 2005 Ford Five Hundred

1 Answer

How to change the brake light on a 2005 ford five hundred


Go to this free Ford website to view or download the users manual for this vehicle. The instructions to change the bulb starts on page 40.
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Jan 17, 2011 | 2005 Ford Five Hundred

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...