2003 Buick Century Logo

Related Topics:

alex little Posted on May 14, 2018
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

How to replace sway bar In 2003 Buick century

1 Answer

Explain Your Issue

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Buick Master 678 Answers
  • Posted on Sep 12, 2018
Explain Your Issue
Buick Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Jun 08, 2009
Answers
678
Questions
0
Helped
194874
Points
2447

Follow the sway bar from left to right and locate the bolts and unbolt them. Replace the bushings before replacing the new sway bar.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jul 19, 2008

SOURCE: 2003 Dodge Caravan Front end clunk.

Had similar problem with 2003 Dodge GC. Replaced the parts you mention + rack & pinion, then to fix the now noticable whining noise, replaced power steering pump and pulley. Fortunately was under an extended warrentee at 46k miles.

Ad

Anonymous

  • 56 Answers
  • Posted on Jan 04, 2009

SOURCE: how to replace a coolant level sensor, 2000 buick century

The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Anonymous

  • 24 Answers
  • Posted on Jan 17, 2009

SOURCE: Where is the radiator drain plug on 2003 Buick Century?

just pull out the holes.

Anonymous

  • 840 Answers
  • Posted on Jan 30, 2009

SOURCE: How to change the rear lights on a 2003 Buick Century.

yes you will you will have to take side trims and sill panel off get a 10 mm ready and take the bolts out the tail liaghts should come out the license lamps have screws in them and if you looka t them but you should be able to twist bulbs and pull them out / Please rate my response thank you very much

Anonymous

  • 176 Answers
  • Posted on May 18, 2009

SOURCE: need unlock code for 2003 buick century car radio

You will need to take the car to a dealership to have the service department unlock the radio for you. They have a special code to unlock the radio and then you are required to change the code to one that you will remember. An appointment should not be needed because this takes about 5 minutes. I do not remember the code, sorry.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2000 Buick Century grinding sound coming from the front end and while turning either direction can feel a thumping in floor. Cv boots are good noticed that right side of sway bar has been removed. ?

need to check c/v axles not just look at the boots -- boots cover the joints and joints wear out have to check for play --check and inspect hubs [wheel bearings] --and as to sway bar replace mising part or whole if its damaged
0helpful
1answer

Noise in left front wheel

Grinding noise, growling noise, thumping noise? Something else? If it's a grinding noise, more than likely it is during stops. In this case it is probably metal on metal in the brake pads. If it is a growling it can be in the wheel bearing or CV shaft which usually gets louder with turning or banking. Is it is a thumping can be from a tire issue, a strut, a sway bar link banging around etc. Need to clarify the noise and how you are hearing it.
1helpful
1answer

I know its a 2.8l v6 I believe its the LB6, looking for some cheap and simple performance upgrades. I've heard you can swap the throttle body from a 3.3 into it? Sway bars? I know it shared with

to swap throttle bodys is posible if you replace all sencers off old throttle body with new one .sway bar may be upgraded but more cost effective to simply tighten them by jaking car up and lossening sway bolts then retightening then unjacking
0helpful
1answer

My sway bar is broken

Let me guess...you live somewhere they put salt on the roads in the winter...they rust in two. Nothing to do but buy a new one and replace it whatever the cause for it breaking.
0helpful
1answer

How much should new fron sway bars cost for my 2003 escape?

You must be asking about the front sway bar links. It would be very unlikely that you would need to replace the sway bar, unless you got in an accident.
I had to replace the sway bar links on my 2002 Escape. They rattled like crazy.
The bars are pretty cheap; about $10 each, from Autozone, for example. But they can be difficult to replace. The upper nut can be tough to get off.
0helpful
1answer

Is there a trick to taking of the cover of the rear brakes of a 2003 Buick Century?

YEP!! use a pry bar between the backup late and drum prying outwards while knocking the fire out of the brake drum with a 3 lb hammer side to side
1helpful
1answer

How to replace a 2003 Buick Century rear tail light assembly?

open the trunk and unscrew the plastic nuts on the back side of the light assy and replace
3helpful
2answers

1995 Buick Century. Under car behind rear axle, bar from tire to tire is detached on passenger side and bounces against ground. What is this piece? And is it major?

THIS BAR IS CALLED THE SWAY BAR IT STOPS THE CAR FROM SWAYING LEFT TO RIGHT WHILE DRIVING THEY MAKE A BUSHING KIT FOR THESE , THE BAR SHOULD BE OK ALL YOU SHOULD NEED IS THE KIT
1helpful
1answer

2000 buick front a-arm mount

remove the road wheel ,unbolt the lower knukle joint first and then the anti sway bar bolt .and so on.look ,observe and think about it do not remove the dampers
Not finding what you are looking for?

206 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...