SOURCE: Adjusting the low beam headlight on a 2003 Hyundai Elantra
thats it my freind one on each side/Plaes rate my response thank you very much
SOURCE: Adjusting the low beam headlight
its all the same the headlight is a complete unit you adjust both/ look for screws behind the headlight one each side one is for horizontal annd the other is for vertical Please rate my response thank you very much
SOURCE: Headlight Aiming/Adjustment
On the sides of the Radiator cross member. Look straight down. Should be a silver colored phillips head screw
SOURCE: HOW DO I ADJUST THE LOW BEAM HEADLIGHTS TO SHINE
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
SOURCE: I Have an Audi a4 Quatro 2004 model. Adjust Low Beams?
There are two adjustment points (screws). For example left headlight: you will see one point near the end of left wing, at bottom side through a wing hole. This is for vertical plane headlight beam adjustment (up-down). Another one point is against water radiator side. This is for horizontal plane headlight beam adjustment (left-right).
378 views
Usually answered in minutes!
×