2013 Buick Enclave Logo

Related Topics:

k
kerry Mason Posted on Apr 25, 2018

How do I replace the rear wiper control arm on a 2013 buick enclave

5 Related Answers

Anonymous

  • 1392 Answers
  • Posted on May 30, 2009

SOURCE: How to remove rear wiper arm

Remove the nut holding the arm. Should be able to lift up on the arm and loosen the joint at the motor.

Ad

Quinn Kessler

  • 85 Answers
  • Posted on Dec 07, 2009

SOURCE: How do I replace the rear wiper arm on a 2008 Kia Sedona

Your wiper arm has an interference fit which means it is essentially pressed on. The best way to remove it is to buy a wiper arm puller, which will have two arms that fit underneath the arm and a bolt that will push on the wiper post, they are pretty slick it should pop right off. Any auto parts store should be able to furnish you with the tool. If you're not going to use it alot, you might call your dealership (or friend with lots of tools) and see if they will pop it off for you.

ZZZoom

  • 151 Answers
  • Posted on Jan 27, 2010

SOURCE: Can't remove rear wiper to replace on 96 caravan

Lift wiper arm from rear window. then release latch that holds the blade to the wiper arm.( It's small tab)

Anonymous

  • 193 Answers
  • Posted on Feb 26, 2010

SOURCE: replace the rear wiper arm shaft

There is a plastic cover that pops off at the pivot end of the wiper arm. pulling up on this with a hook of some kind from the furthest end should release it. Under it you will find a nut that holds the wiper arm to the shaft. It's quite common for the nut to come loose and the shaft spins without moving the arm. Try tightening this nut (with the ignition on, be sure the wiper motor is off, then turn off ignition and put the wiper arm in the parked position). This is a common problem if you've ever tried to turn on the wiper when it was frozen to the glass.

Anonymous

  • 61 Answers
  • Posted on Apr 02, 2010

SOURCE: replace rear wiper arm

there is a cover at the base lift it up and then you have a nut. 10mm remove this and pull off the arm. sometime they get stuck and you will have to pry it up.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Will a transmission out of a 2011 Buick Enclave. Fit in to a 2009 Enclave?

According to Wikipedia, 2009 to 2013 are the same transmissions

In its first year of production, the Enclave was often criticized for its 6-speed transmission, which was "hesitant to downshift."[7] For 2009, though, the powertrain is regarded as more competent with more abundant torque. For its entire production, it has been regarded as too heavy, weighing nearly 5,000 pounds (2,300 kg) with all-wheel-drive. Buick's VentiPorts have reappeared at the Enclave's introduction, a styling feature unique to Buick dating back to 1949.
Initial sales of the Enclave have been very strong, with demand far exceeding production capacity, forcing GM to add a third shift to the Delta Township plant.
With the arrival of the Buick Envision (which is slotted between the Enclave and Buick Encore) to North America in 2016 (for the 2017 model year), the Enclave will be bigger after Envision's debut, and the 2017 model year Enclave will be the last under the first generation platform.
0helpful
1answer

2013 Enclave. What do DTCs P0700 and $07e8 indicate?

po700 is a trans problem tcm communication problem the other is not a code you need to read your user manual and it tells you yo continue so redo your scan
0helpful
1answer

My rear wiper stays on after my switch is off in my 2014 buick enclave

Actually, a new rear wiper module/motor is probably needed. The logic controller is on the motor so the entire motor has to be replaced. I believe the switch is on the center console and I think you will need to remove the outer trim to get at the switch. It may be a switch that just snaps in, so I would get a look at a new one before digging into the job.
0helpful
1answer

2011 buick enclave wipers only work on mist does not work turning switch

Have the BCM module tested, it is the real controller of the wipers, it just gets the input from the switch.
0helpful
1answer

Buick Enclave traction control off, service stabilitrak, engine light on

I recently experienced the same issue. The problem was the pressurized fuel pump. Apparently this is a know issue with the Enclave. When I took my 2013 Enclave to a Buick dealer they replaced pressurized fuel pump ($450 labor and parts) without charging me.
1helpful
1answer

Buick enclave front wipers work only on high speed.

What year ? The relay's are located in the under hood fuse box .
With the ignition in the ON position, accessory voltage is supplied through the 25A WPR fuse to the WIPER relay, the WIPER HI relay and the WSH relay that are all located in the underhood fuse block. Refer to Wiper/Washer Schematics. Which wipers are you talking about ? Front or rear . Rear wiper fuse is in the I/P instrument panel fuse box .
Fuse Block - I/P
Under the lower right side of the instrument panel
0helpful
1answer

Car will not start

Buick Enclave No Start Problems - Car Forums at Edmunds.com

forums.edmunds.com > Buick > Buick Enclave

Mar 1, 2009 - 31 posts - ‎13 authors
Learn more about Buick Enclave at the Edmunds.com Car Forums! Read real ... Time to take it in and see why car will not start with the remote key. Anyone else .... I drove my brand new 2011 Enclave yesterday. It sat for an ... Buick Enclave engine won't shut off. Parking brake light ...
5 posts
Aug 9, 2014
Buick La Crosse Stalling/Starting Problems
31 posts
Jul 26, 2006
More results from forums.edmunds.com

EnclaveForum.net: Won't start from time to time

www.enclaveforum.net > ... > Recalls, TSBs, FAQs, Links & How To's

Jun 23, 2008 - 20 posts - ‎16 authors
I have been having an issue of my Enclave not starting from time to time. If I turn the ignition back off and try again, sometimes it will start after the first ... 2011 Audi Q7; 2009 Audi A8L ... I usually just "flick" the key to let it auto-start and it normally works fine but ..... BUICK ENCLAVE Technical Service Bulletin EnclaveForum.net: 2013 BUICK ENCLAVE ...
20 posts
Aug 14, 2014
EnclaveForum.net: Car continues to run after key removed
20 posts
Nov 13, 2012
EnclaveForum.net: evaporation hose on gas tank - does ...
17 posts
Jun 25, 2012
EnclaveForum.net: Engine won't start low fuel level
12 posts
Feb 3, 2012
More results from www.enclaveforum.net
0helpful
1answer

How do I remove and replace the rear wiper arm on a 2002 Buick Rendezvous?

the nut will be insidse the rear tailgate have to strip out the trim to get access
0helpful
1answer

How *** I replace teh wipper blades

They pop off the wiper arm. You may need a flathead screwdriver. Most auto parts stores will do it for you.
Not finding what you are looking for?

256 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...