360 engine tbi turns over but won't start
SOURCE: removing speedometer 1992 dodge ram 250
I don't know if it's the same as my D150. But it's pretty simple:
1) remove about six screws from under the upper lip of the dash face bessal and one under the overhand above the radio.
2) carefully jimmy the bessal straight out. It has about four spring trim-clips that will release under pressure.
3) this exposes the speedometer instrument cluster. It is one big assembly (speedometer, fuel, temp and elctrical guages, etc) attahed with about six #2 phillips face screws. Remove these.
4) There are three back contections on the cluster: two electronic and one mechanical. Carefully start to pull the cluster out along the steering column until you see the shift indicator control line ( a small fishing-line with a hook on the end) attached to a small steel flang on the base of the steering column. This can be unhooked with your fingers or needle-nose pliers.
5) as you pull the cluster further out you can reach behind and unplug the two electronic connections. The round one simply pulls straight out. The last (rectangular) one has a pinch latch you need to compress to allow the plug to come out.
your finished!
SOURCE: 1992 dodge 318 engine turns over, but no start. No
if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10
SOURCE: Dodge ram won't start and ECM light and check
First you need to retrieve the trouble codes stored in the computer.If you don't have a code reader or scan tool you can take it to your local autoparts store (advance auto,autozone,ect) and they can retrieve them for you.Then we can go from there.
have battery tested if good fully charge,then check all relays and fuses.
95 views
Usually answered in minutes!
×