If i understand your question it is located under the hood around the throttle body. They do not use a cable anymore it is all controlled by computer the sensor is located as i stated on the TBI. Good luck have a mechanic show you where it is at if it is messing up the glass needs to be cleaned. May sound strange but is what needs to be done.
SOURCE: Crank sensor location 1999 dodge durango
the crank sensor is located passenger side back of the engine were the trans and engine come together .there are 2 - 13mm.bolts that bolt to top of the engine.
SOURCE: knock sensor dont work for 2005 dodge durango
this problem is very seldom the knock sensor, it can be the harness connector at the sensor or the engine has excessive knock which will set a code, u did not mention the particular code so hard to say, the location of the knock sensor is the lower section of the engine block, it is screwed into what would normally be a block drain plug, if u replace it u need to torque it to whatever the factory spec is or it can cause it throw another code..
SOURCE: Dodge Durango 1998 5.2L Output Speed Sensor code P0720 Location
Its in different locations depending on if its 2wd or 4wd. For 2wd its in front of the drice shaft or for 4wd its in the tranfer case, just look for a white shape like box with wires plugged into it and you need a socket to remove it, iam not sure how much it is to replace as the cost varies at different shops.
SOURCE: locating and replacing a camshaft sensor in a 2005 dodge neon
this is a very very simple procedure. you do not need pics. there is a sensor located at the end of the engine on the far side from the belts. at the top. it has a plug with two wires in it. just remove the two 10mm bolts un hook the plug and reverse the process to reinstall. if you have a factory intake you may have to remove it to access this sensor. just the intake tube.
92 views
Usually answered in minutes!
×