Cars & Trucks Logo

Related Topics:

Charles Fitzgerald Posted on Apr 14, 2018
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

01 chrysler sebring convertible oil light comes on at idle but goes out when driving 2.7 Oil looks like it just been changed.

Should I be changing the oil sending unit or is my problem greater than that????

1 Answer

Arnie Burke

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Chrysler Master 7,339 Answers
  • Posted on Apr 14, 2018
Arnie Burke
Chrysler Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jul 23, 2009
Answers
7339
Questions
0
Helped
1823011
Points
21459

Add a quart..highr speed givs mor pressure

5 Related Answers

roedmondson

Romel Edmondson

  • 68 Answers
  • Posted on Jan 23, 2009

SOURCE: Where is the oil pressure sending unit on 2004 Dodge stratus

Most likely the oil pressure switch may be damaged. This is a simple procedure. Change and observe the results

Ad

Anonymous

  • 202 Answers
  • Posted on Mar 26, 2009

SOURCE: 2002 Chrysler Sebring Oil pressure light

Could be a bad oil pressure switch, or a bad oil pump. Both will cause this issue. Hope it is the switch b/c the oil pump is a costly repair.

honeymokey

honeymokey

  • 3113 Answers
  • Posted on Jul 02, 2009

SOURCE: oil light on while driving 2002 Sebring

2.7 ? This motor has oil problems if not changed every 3000 miles. Put a chrysler filter on it and the correct weight of oil, never use a fram oil filter.

Anonymous

  • 1 Answer
  • Posted on Jul 24, 2009

SOURCE: 89 vw cabriolet oil light comes on....

i put 20w-50 peenzoil in my cabby and helped a lot. every so often it might do it. but i did just find a vacuum leak that goes from the intake tube to the valve cover. i think if i fix that, it should be solved fully.

Jason

  • 218 Answers
  • Posted on Nov 05, 2009

SOURCE: oil light comes on only when at an idle

I just had the same problem on an 04 Sebring with a 2.7L V6. The oil pressure sensor (switch) was the culprit. Several web references that I checked mention that the original sensors have issues with oil leakage, which eventually causes it to fail. The sensor itself is fairly inexpensive..about $15. It is located on the back side of the engine and is only accessible from under the car. Look for a small heat shield held on by three 15mm bolts. It is just to the driver's side of where the exhaust system goes behind the engine. The oil sensor is located under this shield. You will need a 1 1/4" deep socket to remove it. When installing the new sensor, be sure to use a torque wrench. It needs to be tightened to 14 ft/lb. Using more force than that, and you run the risk of damaging the sensor.

If this doesn't resolve the problem, you may have a problem with the oil pump either being defective or blocked with sludge. As one of the other gurus on here mentioned, this engine does have a known problem with sludge buildup. I hope this helps! Good luck!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2002 Chrysler Sebring convertible-malfunction light on

You need an OBD2 reader to pick up your fault codes.
0helpful
1answer

I have a 2004 Chrysler Sebring Convertable 2.7 Liter. The oil light comes on even after ive just changed the oil. Is there a way to reset it?

Is your oil sending unit bad??? U can reset everything by unhooking the negative battery cable for a few minutes but i dont know if it will help your oil light..Check your connection at the oil sending unit and insure its got a good connection and check for shorts...
0helpful
1answer

What causes my 2008 Chrysler Sebring Convertibile jerks when idle and driving? Does this mean the spark plugs may need changing?

Yes that is one of the first places to start, obviously a full tune up would be desirable, but your probably trying to avoid the costs.
1.New spark plugs
2.Check the resistance of each spark plug lead, as long as all the resistances are similar they willl be ok. if any are quite a bit different change the whole set
3.New air filter element.
4.Change the oil and filter..
5. Possibly a new fuel filter.
the timing and the fuel mixture should not need to be touched
0helpful
1answer

For about 4 months now my 2007 sebring shuts off for no reason after driving on the highway. The oil light comes on and the car shuts off with the key still in the ignition and the car still in drive. I...

Anytime the oil light goes on, I would think that the pressure has dropped, assuming the oil sending unit is working properly.

How long ago was the engine oil changed?
I had a low oil pressure signal in a 1997 Cadillac Deville LImousine which went away after I had the engine oil changed.

Sometimes, the wrong viscosity or oil break down can cause the oil pump not to generate enough pressure for the oil pressure light to go on.

I looked at the Recalls for the 2.7L engine and couldn't find anything regarding engine oil pressure light going on mistakenly, but this doesn't mean that it's not a problem on your vehicle. There are 2 other sized engines for this vehicle.

So, what's the engine size for this Chrysler Sebring?
Does the engine smoke at all after all of this?
11helpful
5answers

Oil light comes on only when at an idle

I just had the same problem on an 04 Sebring with a 2.7L V6. The oil pressure sensor (switch) was the culprit. Several web references that I checked mention that the original sensors have issues with oil leakage, which eventually causes it to fail. The sensor itself is fairly inexpensive..about $15. It is located on the back side of the engine and is only accessible from under the car. Look for a small heat shield held on by three 15mm bolts. It is just to the driver's side of where the exhaust system goes behind the engine. The oil sensor is located under this shield. You will need a 1 1/4" deep socket to remove it. When installing the new sensor, be sure to use a torque wrench. It needs to be tightened to 14 ft/lb. Using more force than that, and you run the risk of damaging the sensor.

If this doesn't resolve the problem, you may have a problem with the oil pump either being defective or blocked with sludge. As one of the other gurus on here mentioned, this engine does have a known problem with sludge buildup. I hope this helps! Good luck!
0helpful
1answer

Oil light on while driving 2002 Sebring

2.7 ? This motor has oil problems if not changed every 3000 miles. Put a chrysler filter on it and the correct weight of oil, never use a fram oil filter.
0helpful
1answer

Oil light

I suspect that the oil pump is weak or it has a lot of miles. I would try a little thicker oil first to see if this helps with the light. Maybe even use a 20/50
1helpful
1answer

2002 Sebring -Odometer Lights Flicker then bing battery indicator

have the engine wire harness checked maybe a communication problem between modules.
Not finding what you are looking for?

493 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...