SOURCE: Blown main fuse on 2003 mazda protege 5.
There are two bolts on the side of the fuse itself. Under the fuse box on each side. Unbolt those and it will come out.
SOURCE: How much should I reasonably
replacement of timing belt $350-$500. aftermarket shops will try to sell you a package containg a belt, water pump, and tensioner pulley. the dealer will just replace the belt, they might recommend to replace the water pump if there are alot of miles on the car, they will also inspect the pulley for wear.
SOURCE: timing marks on 1999 mazda protege 1.6 lx
The book is wrong on each cam gear there are two sets of marks "notches align them facing each other in the center of head nevermind "I" and "E" if correct you'll have both of them making one line in the center of both pulleys and the other set of notches will be 45 degrees below. I found this out the hard way just finished with mine for info and tips on mechanics and parts for your ride visit my site at www.godspeedmotorsportsonline.com
SOURCE: I have a 2003 Mazda protege 5. check engine light no codes
Remove the wire from the negative terminal on the battery and wait a few minutes, then reconnect the wire. This will "reset" the computer and remove the check engine light. If the light comes back on, take it to a Mazda service center and let them read the code. They will be able to tell you what is wrong. Pepboys, Autozone....arent always the smartest cookies and are wrong more than they are right.
SOURCE: 2003 mazda protege 5,changing brake pads caliper
Mazda protege5 rear caliper pistons will not go back by pressure...there is a screw in the back (take off on of the nuts, and turn it clockwise until it's loose. if it doesnt retract the piston while doing it, then turn clockwise a few times and push it in via the other solutions.
672 views
Usually answered in minutes!
×