What is hp and torque rating for a 2001 3.9 V6 in a quad cab Dakota with a 4 spd auto trans ?

Stabilizer bar to frame: 45 ft lbs
Upper link nut: 27 ft lbs
Lower link nut: 35 ft lbs

Here you go watch this video ! 2003 Dodge Dakota 4 7 v8 spark plug change Watch a couple other ones also .

Hi Tim,here's a link to your front hub and how much to torque it. Repair Guides Front Suspension Front Hub And Bearing AutoZone com

The bolt pattern for a 2007 Dodge Dakota Quad Cab should be depicted in a diagram on the owner's manual of your vehicle. You can access the owner's manual for your 2007 Dodge Dakota Quad Cab online at the Dodge website. ------------------------------------------------------------------------------
autel maxidas ds708

Go here: www.alldatadiy.com for a factory repair manual

From the 2001 Dodge Dakota maintenance manual.
Note the numbering of the 6 cylinders and the arrow indicating front of engine.
Firing order: 1-6-5-4-3-2, with distributor rotating clockwise.

Replace the blower resistor.

WOW. You want to put a 3.9 ltr V6 from a 2001 Dakota into a 1998 Dakota with a 2.5 ltr 4 cylinder? And you want to keep the manual trans? Have you considered what you will be using for a fuel and engine managment system? If you have a wrecked truck as a host vehicle then the changover may work. But it will take patience and a lot of work. I don't think the 4 cylinder trans will bolt up but I am not sure - never tried that. However that light duty trans will probably not handle the torque for very long even if it did bolt up. Your local Auto Salvage Yard will have a changeover guide and be able to tell you if that trans will fit either engine. My recommendation is to swap everthing and change that 98 to a 01, auto trans and everything.
Good Luck
Let me know how it goes?

I have seen these trucks do this from a defective TPS.

daigram right side window ,with electric motor