SOURCE: 2000 chrysler concorde switch unlocks but wont lock doors.
sounds like the actuator. I had the same problem. Mine got to the point where it will now only work with the key. Had it looked at by dealer.. actuator is bad. Good luck.
SOURCE: replaced the starter still not cranking also
find the grounding point on the motor and either replace the wire end or clean the surface it bolts to
SOURCE: 2000 ford focus no power to starter moter i can
The mechanic should check on the wires and fuse going to the starter motor and the spare parts . since when you test the starter motor and seems no problem to it ,it means that the problem is in the other spare parts connected to the starter motor .check the alternator if it is good and functioning well. The solenoid you also have to check it to be sure because it is very much connected to the starter motor .those spare parts that are worn out or destroyed , you should replace them .
SOURCE: The beast wont start on the key, battery ok , ign
Hello! The Inhibitor relay is more than likely not pulling...If the vehicle is an automatic the selector switch passes battery when in park on a yellow wire to the relay...If a standard the clutch switch passes ground...if manual, relay is called clutch interlock...located under hood...passenger side fender...Automatic...called interlock relay...drivers side fender to the right of air intake...diagram may be to small to read but I'm limited on size...Light Green wire on clutch switch supplies ground when switch is closed pulling relay...Yellow wire off gear selector switch (park) supplies battery to the inhibitor relay...Wish I knew if your vehicle was man. or auto...See if proper batt. or gnd. is present to pull relay...If proper potential is present and the relay does not pull it is defective...Send a comment...
Guru........Saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
200 views
Usually answered in minutes!
×