Need to test float mechanism in the tank .Sorry this is not a answer you want like fit a new fuse number whatever ? on top of the tank under the back seat is access to the unit ,use a multimeter :
SOURCE: gas gauge sometimes works 1995 dodge b2500 van
It is a reasonable assumption that the sensor in the tank is bad.The gauge in those are replaceable, try the dealer but first price them online, JC Whitney and LMC Truck and so on. I would try the tank first, it isn't the favorite job, but my bet is there.
SOURCE: the odometer speedometer gas gauge and heat gauge do not work
There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
I hope this may have helped,
Tom
PS: I have helped several persons with this issue, please review my profile; good luck with it (also often times with this issue the ABS light stays on)
Testimonial: "thank you you are the only person who had an answer I will try and let you know"
SOURCE: 1994 plymouth voyager heating problems. Just
After the car warms up feel the heater hoses that go into the fire wall from the motor both should be warm if only one is warm and the other is cool the heat valve that opens the flow of antifreeze to the heater core is not functioning locate the valve (either under dash in passenger compartment or in the egine compartment) it has a vacuum line going to it and it should have vacuum when the heat is on if not replace the vacuum line or valve itself. Back flush heater core and also be sure the level of antifreeze is up to the top low antifreeze will cause no heat to occur.
SOURCE: dash board gauges not working on voyager 2000
You need to check your main fuses under the hood first and then check them under the driver side dash board.
98 views
Usually answered in minutes!
×