SOURCE: how do i remove the blower motor resistor on my 97
it comes in from the fire wall on the passenger side under the hood.it will be held in with 2 rivets the new on should just snap in.pry the old one out ,it may break don't worry because the new one does not require any rivets. there should be 5 or 4 wires going to it!
SOURCE: blower motor not working at all. 2003 ram
the resitor operates ground, if theres no power then its a bad fuse under the hood in the power fusebox, or #10 fuse inside the leftside of dash, power for the blower comes from the ignition switch,double check all fuses,if you had no ground to blower then i would say the resistor,make sure you have a good ground on the test light, then check for power with key on again, heres a wiring diagram to help you, good luck.
Testimonial: "The connection on the resistor was bad. Thank you for your help."
SOURCE: location of blower motor relay
better late than never....
The blower relay is one of two identical relays next to the clutch pedal above the fuse panel. I just had to replace mine (1996 Protege DX). I switched the two relays and now the blower works fine. Not sure what the other relay was for... but the car doesn't seem to miss it yet! The relays have H270 panted on the side of the black plastic covers. You have to pull down hard to get the relay off the clip it is fastened to, then unplug the four prong connector. Good luck finding one. The books all call for a 6 prong relay. I am going to find one in a junk yard rather than calling Mazda. I hope this helps... I searched all over the internet and couldn't find any answers so I figured I better post mine here...
SOURCE: 2007 Dodge Ram 1500, blower motor stopped working
Hi, On the passenger side, up under the dash is your blower motor. Have the key on and the fan switch on and bump the motor with you hand. It is the unit with the quick disconnect wire going to it on the right side closet to the wheel well.I took mine out today and cleaned it with spray cleaner for electric motors (NON-FLAMMABLE) and put it back in. There are only three 8 mm bolts holding it in place. I have a new one on order from PEPBOYS($51.00)but for now it's working just fine!
SOURCE: 2006 Dodge Ram The blower motor will not blow. No
Yes, there is a blower motor relay located in the PDC box under the hood. It is a black box with a removable cover, and the underside of the cover will show the correct relay location.
639 views
Usually answered in minutes!
×