SOURCE: Rear seat removal 2000 merc Villager
fold top seat down first
then there is seat clip push seat forward with upward motion
this releases back floor clamps once released pull seat back this releases the front clamps then pull seat out of back door
SOURCE: Mercury Villager headlight assembly diagaram for removal
This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.
SOURCE: 2000 Mercury Sable 24V 3.o engine. Need to know
yes about the upper intake and the only way i know how to check the coils is with a engine anilyser or if the check engine light comes on then you can have the codes pulled and that will tell you which cylender is missfiring this engine has a indevidual coil for each spark plug so thares 6 of them and thay slide right down over the sparkplugs
SOURCE: I need to remove the upper intake manifold plenum.
There are no fasteners inside the plenum, The electrical connection for the injectors is very tight due to a rubber ring gasket the seals the injector assembly to the plenum. Carefully push down on the electrical assmbly while prying up the plenum. You also may have to remove the thermostat and hose. I've done this 3 times on my ladies 96 Yukon.
SOURCE: replacing intake manifold plenum
what the hell is the question here? nothing. remove old one and put new one in.
502 views
Usually answered in minutes!
×