Hi. Before setting the timing colt Mitsubishi 3 V6 engine make sure you know where the timing marks are on your engine, and that you have them set up properly with No. 1 cylinder at top dead center (TDC) on the compression stroke before attempting to replace the timing belt. However, you can also visit https://www.reliable-store.com and download the entire service manual for better understanding. It has all the information along with the diagrams. Good day!
SOURCE: what gearbox oil for 1992 K reg Mitsubishi colt
IT IS SEPERATE FROM ENGINE THERE IS A FILLER BOLT AT FRONT OF BOX DRAIN PLUG IS AT THE BOTTOM NEAR THE OUT UT SHAFTS DRAIN IT AND REFILL WITH A SYNTHETIC CASTROL AUTO TRANS FLUID THIS WILL IMPROVE YOU GEAR SHIFTS
Testimonial: "Very grateful for reply to my query. Reply in mins. I had tried looking for a reply to my question online without success. Thank you."
SOURCE: FIRING ORDER AND TIMING SET UP FOR MITSIBISHI V6
The firing order is 1-2-3-4-5-6. Let me know if you need more info
SOURCE: Mitsubishi Colt Cz3 1.3 2008 start problem in a cold seasons
This dosen't help but.........
I have a similar problem. Every 4 weeks or so the car refuses to start. Again battery is not a problem but if we use cables to jump start from another car it starts fine.
Mitubishi cannot find the answer, only suggestion was to spend £150 on a new key , however the problem has now occured with both of the keys !
First check your oil, and change it if necessary. Low oil will cause the lifters to tap. I wouild recommend adding some high milage oil treatment, like Slick 50. If your oil is good and full, the lifters may be damaged. You can take a quart of transmission fluid or diesel fuel to the gasoline. It will cause it to smoke a little but it may free up sticky lifters. If that doesn't work, you probably have damage to your lifters.
1,119 views
Usually answered in minutes!
×